2000 grand voyager + lights flashing after calibration

2005 plymouth voyager ??? Didn't make plymouth vehicles that year . Plymouth Voyager/Grand Voyager Overview Manufacturer Chrysler Corporation (1974-1998)
DaimlerChrysler (1998-2000) Also called Chrysler Voyager/Grand Voyager (Mexico; USA for 2000 only) Production Body and chassis Class Minivan (1984-2000)
Full-size van (1974-1983) Chronology Successor Chrysler/Lancia Voyager (USA, 2001-2003, Mexico SWB until 2007)

False Oil light alarm - The Chrysler Minivan Fan Club Forums

forum.chryslerminivan.net/showthread.php/5788-False-Oil-light-alarm

Jul 24, 2007 - 10 posts - ‎6 authors
I have an oil sending unit problem, getting false reads,oil light on when stopped ...Forum · The Minivan Mopar Garage · 3rd Generation Chrysler Minivans: 1996-2000; False Oil light alarm .... *1999 Plymouth Grand Voyager SE 3.3L-V6 FFV, 141K miles. ... Car does not have a Tach or oil pressure guage. Oil Light Keeps Coming On
10 posts
Jan 17, 2010
Oil pressure light comes on when brakes applied
10 posts
Dec 11, 2009
oil light flashing
10 posts
Mar 9, 2009
Intermittent Oil Light - Oil Pressure Sensor?
10 posts
Jan 14, 2009
More results from forum.chryslerminivan.net

i have a 98 plymouth grand voyager, when i slow down and

with the head lights off ,and if you step on the brake pedal does the brake lights come on?

What has most likely happened is that the Heater-a/c unit needs to be recalibrated and here are the steps to do so.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent so air blows out of the dash panel outlets.
3. Hold down the rear washer button and the rear wiper buttons simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. I see this fairly often with battery replacements so I think you'll be ok. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time. Good luck, hope this helps!

sounds like the fuelpump might of gone bad the frist thing i would do is to have the fuel preasure checked.start there

the back bulb is out, replace it.

The lights flashing sound be the ASD relay going bad. Its the Main power relay located in the fuse block under the hood. If the AC is not working you may have a leak that was'nt detected. You need to have it diagnosed.

the controls always click when you change the setting as it is electronic, don't panic, but you should ask your ex as he is well up in voyager' s and the back seat not folding down properly!!!!!

Do you have any check engine lights on? Is your anti-theft light flashing? If so, put key in igniton, turn to on (NOT START) leave in on position for EXACTLY 10 MINUTES
As SOON as theft light turns off, try to start.

There is a problem with your key.

cycle key, on,off,on,off,on & leave on (not start) now count flashes of check engine light, 2 digit numbers. For example. flash,flash,flash, pause, flash, flash, flash, is code 33. or flash, flash, pause, flash, is code 21. Write them down & get back to me. when you get code 55, that's telling you end of message.