2002 Volkswagen Jetta TDI Logo

Related Topics:

Luann Kotze Posted on Aug 15, 2015

Torgue settings - 2002 Volkswagen Jetta TDI

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Torgue settings for cyl head ,mais and big ends on 1985 kb2200 isuzu

don t know the torgue for that model but i was told by old timer to spend the money on new bolts. used bolts have been stressed and you take a chance on snapping off after getting hot
1helpful
1answer

2000. Starts fine but why does it die when put in gear?

I think it is your transmission, i believe your torgue converter is locked up, what is happening, when u put it in gear the torgue from the engine is put into coverter, it has a series of cluthes inside that get tighter as force is applied by your transmission, however if the torgue converter is seized, then all of the motors energy is being applied to your trans, then to your axles, since your car is on the ground and not moving it kills the motor.
0helpful
1answer
0helpful
1answer
0helpful
1answer

Engine Torgue settings for Ford Ranger 2006

There are several torque setting for each car. I would suggest you go to the local parts store and purchase a manual and it will have all the specifications.
19helpful
1answer

Torque settings for Nissan na 20 cylinder head

I need the torgue settings for Nissan Hardbody NA20 engine
: Mains bearings, Big ends and flywheel as well as timing belt settings
0helpful
1answer

Need torgue specs & sequence for upper & lower

Lower: Torque to 28 N·m (250 in. lbs.)

Upper: Torque to 12 N·m (105 in. lbs.)

Sequences below:

mf_grimm_1.jpg

mf_grimm_2.jpg

Good luck.
2helpful
1answer

Head bolts

I'm assuming you meant a 1.8L 4V, if so the torgue settings for the head bolts are
stage 1: 30 ft-lbs
stage 2: 44 ft-lbs
stage 3: Angle-tighten a further 90-degrees
stage 4: Angle-tighten a further 90-degrees

Also I recommend you buy new cylinder head bolts from the vdub dealer, they say you don't have to with a gas engine but only with diesel engines you should, from my past experience it felt like the old bolts were going to snap off to be safe buy new ones. If you have never done this before "stage1" this means each bolt gets this one time, then after you have done each bolt at this torgue then you do the bolts again (stage 2) with this torgue ect. Remmeber to always cris cross your bolting and work from one side to the other the same time for each stage. Vdubs 4-ever !
Not finding what you are looking for?

235 views

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...