56 plate LDV Maxus, right hand indicator makes the rear fog lights flash along with the indicator

buy the shop manual and read about that.
only read that book on that DTC , googling P00E3
will get you a pack of lies, RTM
you posted with no country
and cars and trucks are not the same world wide for sure this.

Check for a bad earth and read any OBD codes to gain any clues.

The body control unit needs attention.

You can't unfortunately

Is it on? Is it off? Is it flashing? Why do you say it's not working? I don't understand how you think this is enough information to answer your question. It probably needs a new fuse or a new bulb.

gumtree.com or the dealer.

Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Hi
I know from experience that you cannot really re synch these fobs on the LDV Maxus vans.
What actually is the fault is an onboard component on the pcb has failed and we normally just replace that with a new one..the fob will be tested for operation and sent back. OR its the Relay in the ESA unit - under the left hand front glovebox on the bulkhead - black with cables going into it. We have those relays (soldered to the pcb) we can supply those or do the work for you. The fob connects to that ESA and the unit then fires the relays to open/close the doors. Sometimes that unit is installed upside down which causes water (condensation) to enter the box and have fun with your electrics.
The fob is SYNCHED to this unit via coding we can use your old fob to clone to a new fob and that will work with the ESA and the vehicle.
We have the parts on this link Items for sale from remobilise ltd

Here is a link to how to program the fob to the vehicle via the programmer - NOTE how you MUST have a working fob to program another (text at the start of the video... LDV Maxus flv

We can fix most problems on the LDV Maxus that occur with faults to do with the Central locking/fobs/ESA/ETACS - three relays are in the ESA and they control ONLY the central locking - two more relays are in the ETACS unit (behind the ashtray) and they control the fogs and intermittant wipers.

Any help or info needed please contact [email protected]
or tel 01792 896404.

We are based in Swansea UK.

Hi There. Im not sure where you are but this is the sequence for the UK< Hope it helps.
here are the 7 cable locations and pin numbers.
Pin 1 Yellow L/H Direction Indicator
Pin 2 Blue Rear Fog Lamps
Pin 3 White Earth Return
Pin 4 Green R/H Direction Indicator
Pin 5 Brown R/H Tail & No, Plate Light
Pin 6 Red Stop Lamps
Pin 7 Black L/H Tail & No, Plate Lights

I found the easiest way to locate the correct wires in the loom is to turn on the lights required and use a circuit tester and splice into the main loom where you have enough wire to play with. Try not to cut the loom as it only causes more problems with bad connections and joins.(
Good Luck

hi, this sounds like you have a bad earth at the rear lights, remove both rear light clusters and check for any signs of corrosion, give all connections a clean and a little tweek, this should cure your problem