Where do I find inline fuse for back brakes, 2004 Chevy express van?

SOURCE: 1996 chevy express van audio wiring diagram

go to www.the12volt.com

Johnny Brown

• 5763 Answers
• Posted on Oct 27, 2009

SOURCE: Where is the fuel filter located on a 2004 chevy

under van in front of fueltank near frame on driverside,hope this helps.

SOURCE: Reverse and interior lights out, chevy express van

Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.

There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.

Duane Wong

• 6826 Answers
• Posted on Oct 18, 2010

SOURCE: How do you change the

Axle Shaft Bearing & Seal Removal & Installation To Remove:

1. Raise and safely support the vehicle.
2. Remove the axle shaft.
3. If replacing only the seal, remove the seal using a suitable seal removal tool.
4. If replacing the seal and bearing on the 8.6 inch axle, install the slide hammer and adapter behind the bearing and pull out the bearing and seal together.
5. If replacing the rear axle shaft seal and the bearing on the 9.75 inch axle, install the J 29712 or equivalent bearing puller into the axle housing behind the axle bearing.
6. Remove the axle shaft seal and the bearing by tightening the nut on the J 29712 bearing puller.

1. Install the axle shaft bearing using a suitable size driver. Drive the bearing into the housing until the tool bottoms against the tube.
2. Lubricate the seal lip and install the seal with a suitable seal driver. Make sure the seal is fully seated in the axle tube.
3. Install the axle shaft.
4. Fill the rear axle with the correct lubricant.
5. Lower the vehicle.

SOURCE: I need a diagram of fuse box for 2000 Chevy Express Van

i have a 2000 Chevy van where is the fuse for the two(2) rear power outlets