I would also make sure there is no play in the wheel hubs because if there is when you apply the brakes the rotors will touch the backing plates.
Try cleaning the Hub of the wheel bearing assembly where the rotor attaches, if there are any rust scabs it could make the rotor turn with excessive run-out.
You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete.. eg. pls try reliable-store.com
I have a 2012 equinox. Replaced pads and rotors. Have a grinding/squeaking, horrible sound only when applying the brakes lightly.
If it started after the pads and rotors were changed, check for bent backing plates rubbing on the rotor.
SOURCE: 2005 Chevrolet equinox brakes make groaning noise
if you feel a pulsation in pedal when stopping, its the rotors that need changed. good-day and may god bless !
SOURCE: My 2006 Chevy equinox is making a clicking noise
wheel speed sensors, is the light staying on for ABS ?
SOURCE: Front end rubbing or grinding noise but goes away
It could be a number of things, but a common problem with this car is rusty pins in the front end. This is louder when turning. There was a bulletin issued about it.
SOURCE: Grinding noise braking at slow speed hard right turn
The problem is either a bad CV joint or is it possible that the brakes are worn.
3,225 views
Usually answered in minutes!
×