I don't believe this veh. was one of the ones recalled by GM for faulty ignition switches
SOURCE: installing ignition switch for 87 chevy s10 Blazer 2.8L 4X4
you need to replace the electrical part of switch?If os it is down on column under dash will be two bolts holding on with the dimmer switch also
SOURCE: Key stuck in ignition of 2002 chev. trailblazer
Remove the cover of the switch, there is a silver button below the place where you put the key. Press it and the key will be released!
SOURCE: key stuck in ignition. Won't turn to the off position
Sounds like a very warn out lock and tumblers. Try angling the key as you turn the lock.
SOURCE: can't remove key from ignition. battery is dead
If the battery is dead, the ignition keys will not release from the ignition. If there is no signal from the transmission shifter that it's in park since the battery is dead, then the ignition lock will not release the keys. After charging the battery or jumping the blazer to start it and the key's still will not release, try this.
There is a "plunger" as part if the ignition. Under the steering wheel there is a small removable cap that you can take off and put a small screw driver up into and press the plunger in and it will release the key. Good luck and hope this helps, Keep me posted be glad to help.
SOURCE: 2005 Chevy Impala ignition switch stuck in off position
if it doesnt turn you have a worn out ignition cylinder, the only fix is to replace it, Code the ignition lock cylinder, if necessary
CAUTION:Perform the body control module (BCM) theft deterrent relearn procedure whenever you replace the ignition switch lock cylinder.
429 views
Usually answered in minutes!
I had the same trouble with my 2005 blazer. It turned out to be a loose wire from a plug under the canter floor console in front of the shifter replaced the plug Napa auto part #EC1196. No trouble since poor design as the wires move with every shift. Make sure to leave some room for play in the wire bundle
×