Driver side power window stopped working. Passenger side still works. Is this a fuse issue?
Check the fuse snd the motor and contacts
Both windows operate on the same fuse. The motor is probably bad. You will have to probe the wires to the window switch to make sure the motor is getting power. If no power on the switch you could have a broken wire in the harness between the door and the body. If you have power the the door panel should be pulled and check the power on the plug at the motor. If power on the plug then the motor needs to be replaced.
The module. We offer a repair service on C5 corvette door lock modules, please check this out and let us know if you have any questions. Thanks
Steve
http://autoclockrepair.com/
Had the same problem, everything worked but the driver side window and door lock, I had it diagnosed at Chevy dealership and the problem was the driver door control module. the price from Chevy was around $ 775. I found the part new on eBay for $150 and had Chevy install it for $98. hope this helps
SOURCE: Driver Side Window won't work- Chevy Blazer 2003
If it does not make any noise, or sound like its getting any power, most likely its the switch.
SOURCE: passenger power window does not work 2002 Silverado HD Ext Cab
i have a 2000 silverado and the windows usally go down fine. but when i roll them up i have to hit the button repeatally to get them to go up. this ison both windows. any suggestions
SOURCE: 2005 Chevy Colorado drivers side window, and power locks
Check for door ajar switches not making contact.
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
864 views
Usually answered in minutes!
×