SOURCE: how do I replace the transmission coolant lines
Take a small 90 degree pick. Inspect the fitting closely. Use the pick to "roll" the retaining clip off the fitting. The line will simply pull once this is done. U can install the clip first on reinstallation (inspect them closely) and then simply push the line into the fitting. It will "click" into place. Note u will have to orient the line perfectly to push in.
SOURCE: Drain Engine Coolant in 2005 Chevy Silverado 2500 HD
there is a petcock at the bottom of the rad drain ti from there and use a antifreeze tester to check protection temp
SOURCE: co265 ebcm motor relay circuit p/n 88982286
Hello, your EBCM is located on the frame underneath the vehicle just below the driver's seat. Sorry, I don't have a picture of it. Have you had brake work done recently?
1,749 views
Usually answered in minutes!
×