2008 engine trouble light reset

Try locking and unlocking the doors with the key fob to see if it corrects the problem. You can also try using the key and locking and unlocking the drivers door only

You'll need to have the computer checked for trouble codes to proceed.

The check engine light is telling you the computer has found a problem with the performance of the engine that can affect fuel mileage or emissions. You have to have the computer scanned for trouble codes, fix the problem, then clear the codes from memory to make the light go off. An auto parts store can scan the computer for free but the light will stay on until the problem is fixed.
The problem with the wipers could be the delay part of the motor.

By a cheap odb2 reader read code then delete codes,,with no check engine light on it will crank with remote start ,,a few times,,,,or til the light reappears ,,,you can also take the neg cable off the battery for 30 seconds to clear the codes,,, remote start should work after that if no engine light

The remote start will become inactive if the check engine light is on. You will probably need to go to shop to find out why the check engine light came on but alternatively if there is an advanced auto or Autozone they can scan these free of charge and tell what code or codes caused the engine light to come on and possibly what needs repared to correct the engine light.Once the engine is taken care of the remote start should start working again. The tire may just need replaced and all tires aired to proper pressure. Many of these once the condition are corrected driving them for a few minutes will reset the tpms but if it does not the tpms may need to be reset by a qualified shop.

there are several reasons why the remote start won't work, and one of them is the presence of a check engine light. Normally a check engine light comes on when a trouble code is present and recorded by the engine control module. Resetting or erasing the codes can only bring temporary relief, like what u said the remote start worked again. But the trouble will still come back until the real cause is being addressed. You got code on the cam sensor, but car runs fine. Its because the engine computer senses inconsistencies while trying to improve the Emissions system of your vehicle. That we cannot see or hear. Most probably your cam sensor or the wirings are getting intermittent. Better have it visually inspected and replaced if necessary.

P0496 2013 impala purge valve

put key in ignition and turn to on position push key fob to on/off positen for about 30 seconds this should reset system.adrian.,,,,

it could be just the battery in your key fob,, it takes more "juice" to use it for the remote start

1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.

Without multi-information display

1. Continue to press and hold the button until the trip meter displays 000000.

With multi-information display

1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.

there you go jimmy mark as fixya