Where is the TCC solenoid pack located on a 1999 Chrysler Town and Country?

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

SOURCE: Where is the Body Control Module located?

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the bcm.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the bcm to the jb. Slide the bcm downward to disengage guide studs on jb from channels on bcm mounting bracket
Remove bcm from jb.

jimmy nutron

• 132 Answers
• Posted on May 30, 2009

SOURCE: 1999 chrysler town and country--no a/c

bypass the relay and test it you can take 2 wiles black coming off of it is the negative or ground wire if it dosnt work on direct power it compressor is bad and you need a new one

SOURCE: how to replace our low beam headlight on 1999 town and country

1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

Greg Bernett

• 2993 Answers
• Posted on Nov 13, 2009

SOURCE: Front PCV Valve on chrysler town and country

PCV valve location-2.4L engine


PCV valve location-3.3L and 3.8L engines