SOURCE: CHEVY 2009 IMPALA
Hi, the airbag flashing light
on your car is telling there is a problem. On some vehicles, the light
is flashing a two digit code. Your vehicle will require a scan tool for
the proper diagnosis (and not the one at Auto Zone---it needs to be
airbag system specific, like a good body shop or the dealer).
Here's a site that will explain everything you need to know about
airbag lights and resetting the system. Once you know the code, you can
most likely repair it yourself. There are fairly easy procedures that
most people are capable of repairing.
Airbagsolutions.com has the fault code charts to tell you what is
wrong! Although it's a pay site ($14.95/day), it's a lot cheaper than
going to the dealer.
SOURCE: 98 Chevy blazer won't start up but will crank ,,
Try giving it a shot of starting fluid. You don't say if it's actually firing. If it tries or runs for a few seconds off of the starting fluid then try changing the fuel pump relay. It's inside of the glove box on the left hand side behind the little door. If that doesn't work it's most likely the fuel pump.
SOURCE: 2002 Chevy Silverado 2500 diesel
Check and make sure your glow plug controller is putting out voltage to your glow plugs, make sure voltage to your glow plugs is cycling. if it is not, at the front of the engine there is a temperature switch, if this switch is not working your glow plug controller will not work. also make sure you are getting diesel to your injector pump, if you are not, there is a high pressure switch at the back of the engine right behind the glow plug controller, if this switch is not working, your injector pump will not get fuel. also make sure both batteries are fulley charged, if one is low, your diesel will never start. you can jump out these switches, if your truck starts after bypassing, just make sure to replace them. i have a 1993 silverado C3500HD 2WD. good luck!
SOURCE: 2009 HHR won't start. Battery is good.
Is the security light on or blinking?If not then do you have power to the starter.You can check this with a test light.You should have power when you turn the key to start.The test light should light up.Should be the small wire.I believe it is purple in color.If the security light is on then you will have to get the codes to see what is causing the no start.Hope this helps.Good luck.
SOURCE: 2005 pt cruiser won't start won't crank, everything works
When you turn the key on the ASD relay should turn on the fuel pump and power the injector, Do this lets cheat the system go to the ASD rely open the cover expose the inside have some one turn the key on does the ASD make contact? If not turn the key on collpase the ASD so it make contact do you hear the fuel pump come on? Now try this just as how you iopen the ASD do the same to the starter relay. Put the car in gear e brake on someone in the vehicle in case the car start and you are in front of it and it runs you over so at least they step on the brakes. Key on ASD exposed as your collapse the starter relay does the ASD relay turn on? Here why if you can control all the relay from under the hood you will need a ignition switch (the eletrical part)
705 views
Usually answered in minutes!
×