CONNECT TESTLIGHT BETWEEN NEG. BATTERY CABLE AND BATTERY NEGATIVE, WITH BATTERY NEGATIVE DISCONNECTED. MAKE SURE DOORS ARE CLOSED, KEY OFF, LIGHTS OFF, ETC. ELECTRICAL DRAW WILL LIGHT UP TESTLIGHT WELL. CAREFULLY REMOVE FUSES, ONE AT A TIME WHILE WATCHING LIGHT.WHEN LIGHT GOES OUT OR DIMS, THAT IS THE SYSTEM.BE SURE TO REPLACE FUSES AFTER REMOVAL UNTIL YOU FIND THE ONE THAT AFFECTS LIGHT! NOW YOU CAN UNPLUG INDIVIDUAL COMPONANTS AND CONNECTORS UNTIL CULPRIT IS NARROWED DOWN, BE CAREFUL BECAUSE WIRES ON THESE ARE NOTORIOUSLY FLIMSY, AND BE SURE TO CHECK FOR A WIRE WITH A HOLE RUBBED IN THE INSULATION.
SOURCE: I can't open the gas door on my chevy aveo.
To open the fuel filler door, pull up on the release lever with a gas pump symbol on it. It is located on the floor on the left side of the driver's seat.
Please leave feedback if this helped. Thanks!
SOURCE: What are the optimal shift points for a 2009 Chevy
I uually shift into 2nd at around 10 mph 3rd at 25 4th at 33ish and 5th at 40. I get 30 mpg on a 2006 Aveo which only has a 27 mpg rating for my car. The high way is a totally different story. I dont look for gas mileage for quickness. But If you want the recomened shift points look in your manual. I learned the early shifting tric from my 01 focus. It had a shifting light. I got 33 intown mpg with that one
SOURCE: lMy 2009 Chevy aveo oil
I believe it means that your car is due for an oil change. Your cars computer is programmed to turn that light on every so many miles to alert you and then after you change to oil there is a procedure to reset it. You owners manual should tell you this information of what the light means and how to reset it. If you do not have the manual call your local dealer and ask the service dept. what it means for sure and they should tell you over the phone and if it's a good dealer they will tell you how to reset it.
SOURCE: How to start the relearn procedure on a 2009 Chevy
There is a relearn procedure for the transmission but you need a Tech 2 diagnostic with the appropriate software.It only for automatic transmissions. The clutch data is learned which translate adaptive data cells. Which the TCM uses for clutch controls during shifting. This is for the fast learn procedure.There is another method that I will find later
630 views
Usually answered in minutes!
×