I have a 2008 Chevy Impala SS with a 5.3L V8. I am looking for the throttle postion sensor, but have not been able to find it. Can you tell me where it is located on the engine application?

SOURCE: Service Throttle Control

my 2007 chevy impala check engine light is on sayin reduced engine power but mine wont start whats tha problem

SOURCE: how do you remove the old car battery on a 2008

1. Disconnect the negative battery cable.
   
2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
   
3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
   
4. Loosen the positive battery cable terminal nut.
5. Remove the positive battery cable terminal from the battery.
6. Reposition the underhood accessory wiring junction block.See steps 9-14.
   
7. Remove the battery retainer bolts (1) and retainer (2).
8. With the aid of an assistant, remove the battery.
9. Remove the electrical center cover (1).
10. Disconnect the positive battery cable from junction box
11. Remove the fasteners (1) securing the electrical center board (2).
12. Unlock the tabs on the electrical center board.
13. Lift up on the electrical center board.
14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Tech jk

• 102 Answers
• Posted on May 08, 2009

SOURCE: on a 2006 chevy impala it tells you to tighten the gas cap

There is no sensor for a loose gas cap. What is happening is that the evaporative emission system is sensing a "Large Leak". Usually code p0455. The computer sees this as the most probable cause is a loose gas cap depending on several factors it looks at. You would need to clear the code(s) and see if that was the problem. If the light comes back on, then you have a problem in the system that will not let it seal. Possible solenoid problem, leaking hose / line, etc.

SOURCE: I have a 2008 chevy impala. The car suddenly

ur vehicle is in limp mode[ a safe mode ] which will get u home trying not to cause any damage to engine --theirs a few reasons the vehicle will do this-low oil pressure-transmission problem-have vehicle scanned most auto stores such as auto zone / advanced auto [check ur local area]do this service for free the code gives u a start point towards resolving ur problem

SOURCE: changing a thermostat on 2008 Chevy Impala 3.9L

There are two hoses that come from the radiator. The very bottom hose is conneted to the thermostat housing. Looking at the car from the front under the hood just below the first hose is another one same in diameter and there it is two bolts and you done.