At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The light will go out when the washer fluid tank is filled, if it is full then the level sensor is defective and you need to install a new one, it is located in the washer fluid tank.
The sensor inside the tank is defective or covered in goo. Remove the sensor from the tank or remove the tank and flush it clean with hot water and a mild solution of white vinegar, if the sensor still reads the tank is low replace it.
it is the fuel level sender. the board will wear and cause it to lose signal; in certain spots. will need to replace the sender to fix problem. it will start registering once you burn some gas off. full is just where it drops out
Hi I have a 4x4 2003 chevy 3500 silverado dually with dual tanks
rear tank stoped pumping into front tank and was full . I siphoned the fuel out of rear tank and fuel gauge reads 9/16 full . is there a way to reset the fuel sending units so they can calculate the fuel readings. I always filled the two tanks with the same amount of fuel
until now ? I'm thinking there is a inkine fuel pump
×