Crank sensor been changed
SOURCE: 03 Altima ( 2.5 ) crank position sensor - retired ASE Master Teck
and YOU took much to long to answer --BUT thanks for your attempt -
SOURCE: i have a 55 maxus ldv van. i have problems
sounds like it could be the pressure control valve on the fuel pump not an expensive repair. the pressure drops in the line over night. try priming the filter whilst the engine is being cranked. the control valve is held on by 3 torx screws on the end of the pump.
SOURCE: crank position sensor
if you have the 2.4l it is located behind the timing belt on the crankshaft. possible causes include timing belt teeth seperated or balance belt teeth seperated and taking out the crankshaft sensor and sensor plate. this is no easy task for the home mechanic.
SOURCE: check engine light come on fault codes PO165 and PO155
Yes sorry but they both should be replaced.
SOURCE: 97 Chevy Astro van lugs, like it misses, B4 finally cranking on
crank shaft sen. is easy enough to change.its mounted near timing chain cover,cam sen.is somewhat harder,its in the distributor,id doubt that both are defect
3,988 views
Usually answered in minutes!
×