SOURCE: changing fuel filter on 2004 chrysler town and country
SOURCE: location of the speed sensor on 1996 town & country
they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff
SOURCE: locating fuel filter 1996 Town & Country 3.8
they say its on the right hand side slighty above the gas tank by the sending unit might have to remove the one strap
SOURCE: where is the body control module located on a 1997 town & country
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
SOURCE: where is the oxegen sensor located on a 2000
the oxygen sensor is located in the exhuast pipe,there could be more than one sensor, maybe 4 sensors on a 6 cylinder car and 2 sensors on a 4 cylinder car,so youre gonna have to know which one is bad,if the check engine light is on it will tell you which position sensor is bad like bank 1 sensor 2 something like that,also there is NO fuse for the o2 sensors
68 views
Usually answered in minutes!
×