20 Most Recent 2001 Toyota Sequoia Questions & Answers

Codigo de camioneta sequoia codigo p0300 o P0305 Cilindro 5 fallo de encendido detectado, pude ser que salto un martillo, donde pisa la valvula o este doblada esta son cuatro por cada cilindro si una esta cerrada produce la falla en alta

Go to the dealer take proof the car is under you name with the vin no. They will make u a key and it will bw the same as your old one it will start you car

For radiator replacement procedure. I suggest you to click the link below and follow the detailed procedure :-----

How to replace Radiator?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-radiator-on-audi-and-vw.html

---------- HOW TO REPLACE AN UPPER RADIATOR HOSE

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-upper-radiator-hose.html

------------ HOW TO REPLACE A LOWER RADIATOR HOSE

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-lower-radiator-hose.html

------------- How to replace Radiator on Car models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-radiator-on-acura-car.html

------------ How to flush cars radiator?

http://repairhelpcenter.blogspot.com/2011/11/how-to-flush-cars-radiator.html

-------- HOW TO PRESSURE TEST A RADIATOR AND CAP

http://schematicsdiagram.blogspot.com/2011/07/how-to-pressure-test-radiator-and-cap.html

---------------- HOW TO REPLACE A RADIATOR

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-radiator.html ------------------

HOW TO REPLACE A RADIATOR SUPPORT

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-radiator-support.html

-----------

This details will help.

Thanks.

not enough information james.

https://www.youtube.com/watch?v=bChKblpCD2Y https://www.youtube.com/watch?v=VBiKANHjDag https://www.autogenius.info/toyota-sequoia-2005-2006-fuse-box-diagram/

https://www.youtube.com/watch?v=y66H4Z0S-Kg https://www.youtube.com/watch?v=PJGACK4IwF8 https://www.youtube.com/watch?v=bWgGXhOrm0I

https://www.youtube.com/watch?v=OUVJSeUATuI https://www.youtube.com/watch?v=74XJSeRp2II

My brother had the same issue on his RX300. https://www.youtube.com/watch?v=qJRmHxZoZIM

yes, it sounds like the problem is there. There is a spiral cable unit directly below the steering wheel that is most likely the problem, the air bag circuit and horn circuits go through this spiral cable. I probably needs to be replaced.

Did you use the correct coded key?

it depends if they took the manifold off to do the cat converter job If they did it is their repair cost as the job was not completed properly if that was not necessary then they may have broken the flex bit just from the manifold

Check the trailer hitch tap connector in the frame near the rear bumper for corrosion. Use dielectric grease and reconnect the connector

Best plan is to buy a new key. Dealer can supply this if you show VIN and proof of ownership. Pricey, but still the best option, IMHO.

Getting your system recharged at a dealership would be recommended but only hot air coming through the front could be an hvac problem, make sure that all your vacuum lines that run to your system are not crushed or unplugged, they will be located in the engine bay of your vehicle.

Hi Complete Auto: - I would first check to make sure that I had the correct amount of oil in the engine. Basic, but essential. - The valve tapping will be happening due to too much clearance between the rocker arm and the valve. Follow that back and there will be slack between the rocker arm and pushrod, and then back to the lifter. - The lifters have an integral hydraulic action that pumps oil through the hollow pushrod to the rocker arm assembly. - If the lifter "pumping" has failed due to contamination or some other reason, it will need to be replaced. - If there is too much slack and the rocker is adjustable, slack off the lock nut and turn the adjustment until the tapping stops. Then tighten the lock nut and re-install the rocker/valve cover. Hope this helps. Cheers.