20 Most Recent 2000 Daewoo Lanos Questions & Answers

facing the front of the car, the camshaft sensor in on the left end of the valve cover. their is a plug in their for the sensor.

mcdevito75 here, that is a shop job only, special tools may be needed to do this job. Best bet let your local repair shop do this job, It"s going to cost you more in time and effort to change the timeing belt than at the shop.

In the engine compartment driver side a Blake box remove cover turn over cover inside it will be marked.

Daewoo cars have track record for dependability in addition to solid construction. The most important part of a car's design is the safety features. Circumvent excessive risk while motoring by insuring that your car has the safety gear that you want. A vehicle's Neutral Safety Switch is located on your clutch in the case that it's a manual transmission, and on the shifter in an automatic. A broken Neutral Safety Switch can cause your vehicle to suddenly start in gear, causing vehicle damage or personal injury. If you don't have the Neutral Safety Switch, your vehicle will fail to work. The Neutral Safety Switch is typically situated below the clutch of trucks which have a stick-shift transmission. The primary function of a Neutral Safety Switch is to stop your truck from starting when in gear. The car's Neutral Safety Switch acts as a safety feature, keeping you from starting the engine if the car is in gear. The Neutral Safety Switch is an electronic part which is essential while starting your car.Here's a link to what it look's like.

While spinning wheel, tighten nut to 18 ft-lbs/25 Nm, loosen nut 180 degrees (1/2 turn), tighten to 18 in-lbs/2 Nm

7 - TP Sensor (Throttle Position)
This is the problem with my vehicle i have a Honda cat turned cherry red smoked the color was white and i looked at the ecu for the flash codes i got 7 witch is stated above replacing that sensor should help the problem. I am doing the same thing tomorrow going to buy the part install it and hope it fixes everything if not i will come back and let you know. everything above you say i am having the same issues so its not just you :)

HI
is the service engine light com on when you turn the switch on ??
if no . check fuses ??
if yes . check the CKP crankshaft position sensor ??

give us more details to can help you pleas !!!
with my best wishes

Have to changed your air filter.

under ur hood

You can check your motor mounts. They can cause your engine to shudder. With the hood open, have someone shift into drive and watch the motor. If it rocks severely more than likely your motor and/or transmission mounts are broken or ate bad.

Hi, This Might have nothing to do with your problem, but you have nothing to loose by the sounds of it, the breather pipe from the bottom of the sump (behind the starter motor) to the top of the rocker box, mine was clogged up with slug like greese causing sencer problems and giving false information to the computer. (running rought) you got nothink to loose, try it.

Chris

either bad rings or head gasket

Check camshaft oil seal also if head wasn't skimmed or not torqued down properly & with new bolts it could be leaking out of head gasket

What won't pump?