20 Most Recent
2000 Isuzu Amigo Questions & Answers
Location of thermostat
Follow the big hose from the top of the radiator back to the engine. IT is in the connection where the hose fits on the engine.
Wizard isuzu
what country?
seen where?
on dash cluster display?
or a scan tool.?
what engine option.?
No reverse and it goes first gear neutral
check transmission fluid, if the level is good check for a burnt smell from the fluid on the dipstick. A;lso shine a flashlight on it at an angle to see if any metal fragments are on the dipstick, If the fluid is full there is a good chance the transmission will need to be replaced. A professional diagnostic would be recomeended at this point to avoid unnecasary repairs.
Which fuse handles my licence plate light?
It should be the taillight fuse or instrument panel fuse . there is a small panel to the left under the steering wheel that has fuses in it and there is also a fuse box under the hood on the passenger side .
Corsa head torque settings?
for 4ee1
cylinder head
stage 1: 40Nm
stage 2: 60° - 75°
stage 3: 60 - 75°
let me know if u need any more of those
take care
2000 amigo intermitent wiper relay location
The actual relay is in a box called "alarm" which is mounted behind the glove box under a vent. The alarm part is a chip that dings when you leave the keys in the ignition. The box has other relays including one for the horn.The circuit board and box are a couple of hundred dollars from the dealer, or you can solder in a new relay for the wipers.
Where is the blower motor located
Behind the dashboard with the heating matrix. You may be able to get to the blower motor from under the dash but it will be difficult. The ideal solution would be to remove the dash it's a pain and you will need a set of hex bit sockets.
P0462
P0462 fuel level circuit,This is a need sensor for the ECM,to know the fuel volume in the tank.The sensing unit uses a float in the fuel tank which moves a wiper across a variable resistor,When this circuit is high or open or has a high resitance P0462 is set. To trouble shoot first inspect the connection the male to female connection.
Not finding what you are looking for?