20 Most Recent 2006 Ford Focus Questions & Answers

The following link will provide you with all OBD-II codes for your Focus. CLICK HERE

Pull up on the brake pedal, see if stop lamp goes out? You may need to check stop lamp switch and brake pedal arm? Pull that fuse in diagram, see if it kills the stop lamps? At the bottom left, in diagram, see the green wire with yellow tracer, that wire should not be hot unless you step on the brake. You can use a test light to check for voltage. good luck

Hi Ray,

I put in some time at an auto salvage yard. Aluminum wheels were big sellers and not something we wanted to damage.

When the lug nuts needed some persuading, we got out the high impact 12 pt deep sockets.

First try we used the correct size.

If they were stripped, one size smaller. We hammer them on to the lug and use a breaker bar with a pipe extension.

The only real problems we had were getting the lug nuts out of the sockets.

Good luck and best regards,
Mike

What make, model is it?

fixya doesnt sell products --dealer junkyard or online search

I have a 06 SES ZX4, same foaming and whining, burped fluid out the cap, progressively worsening in the cold weather. After reading several blogs, found the Ford TSB 08-18-9, and looked at my reservoir O-rings. The outboard ring looked bad, inboard was visibly OK. Replaced both, fixed my problem (Oreilly Auto Parts). Another blogger said he found a filter in his reservoir, mine did not have one. Also, fluid is dark, will be flushing very soon. Car has 130K miles.

You have probably left off or not plugged in a connector properly. They are only supposed to plug in 1 way but sometimes can be forced in back to front. Check all the connections and multi plugs.

Fuse box in glove box,fuse 39 20 amp,diagram in fuse box

Under right front wheel well remove dust cover it's behind it under front side

Better leave it alone and take to shop to do. You may incurr more cost if you damage ECU.

If you closely examine the door where it bolt up to the metal is probably bent a little so when you tighten up the mount its just not tight, bent the metal a little and should tighten things up for you. If nothing else take the other side off and look at how this are shaped on the other side.

Check your catalytic converter under car...When it starts to clog up...Your car want accelerate correctly...Puts back pressure on your motorr

Check out the front drive shaft cv joints for broken boots and worn joints.

check for cruise control - check cable for cruise control is not stuck. check throttle cable may need oil poured into the cable. Check floor mat is not wedged onto accelerator pedal

on the radio keep pressing the mode button until blue tooth comes up go from there all the details are in the user manual