Top 10 1987 Chevrolet S-10 Pickup Questions & Answers

Cars & Trucks Logo

Question

  • 2,283 People Helped

installing ignition switch for 87 chevy s10 Blazer 2.8L 4X4

After tearing down steering column we find it impossible to remove ignition switch. How can we get this switch replaced and is it in the column? I have been told that it may be under the dash on the column. Please help with reassembling too

Posted by on

Answer

  • Most Helpful of 1 Answers

you need to replace the electrical part of switch?If os it is down on column under dash will be two bolts holding on with the dimmer switch also

Posted on Aug 28, 2008

Question

  • 3,600 People Helped

87 chevy s10 4x4 vacuum diagram

I have a 87 s10 2.8l 4x4. The vacuum lines for the 4x4 are not hooked up. Does anyone know where these three lines go? A picture or some direction would be fantastic.

Thanks

Posted by on

Answer

  • Most Helpful of 1 Answers

NOTE<< If Picture Does Not Show Please Email Me @ [email protected] And I Will Send it to You It IS DETAILED And COMPLETE Diagram of Exactly What You Ask For.

Vacuum and Vapor Hose Diagrams Notes Vacuum Actuation System 42242444

Posted on Feb 13, 2009

Question

  • 6,190 People Helped

i need a 1987 chevy S10 vacuum hose routing diagram

1987 chevy S10 vacuum hose routing diagram

Posted by on

Answer

  • Most Helpful of 1 Answers

Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.

Posted on Apr 09, 2009

Question

  • 2,688 People Helped

1987 chevy s10 2.5l tbi will not start. changed

1987 chevy s10 2.5l tbi will not start. changed bad fuel pump works well now strong pressure to throttle body. change fuel pressure switch, oil pressure switch, o2 sensor, map sensor, distrib cap, rotor, electric part on dustrib, check for 12v to fuel injector good, check ground good, fuses good, ecm swapped. truck will run if using starter fluid.

Posted by on

Answer

  • Most Helpful of 5 Answers

That eliminates the crankshaft and camshaft position sensors. Have you checked the fuel injector itself for an open winding or stuck valve plunger? There should not be a steady 12 volts to the injector--if good injector, it would be spraying fuel steadily into the throttle body. But at least the engine should try to run if poorly. Take the injector out, dry it off with air, and intermittently apply 12 volts to one terminal while grounding the other. You should hear a click from inside every time you touch 12 volts. If not, replace it. If it does, it may be plugged with debris. Try blowing through it in reverse with compressed air.

Posted on Jul 17, 2009

Question

  • 2,550 People Helped

1987 chevy S10 engine idle problem

1987 Chevrolet S-10 Pickup1987 chevy s10 2.5l tbi will not start. changed bad fuel pump works well now strong pressure to throttle body. change fuel pressure switch, oil pressure switch, o2 sensor, map sensor, distrib cap, rotor, electric part on dustrib, check for 12v to fuel injector good, check ground good, fuses good, ecm swapped changed fuel injector engine runs now but runs high idle and will not wind down. when i step on gas engine bogs down

Posted by on

Answer

  • Most Helpful of 2 Answers

relace the throtle air idle valve.The temp switch will allso cause this problem.

Posted on Jul 19, 2009

Question

  • 1,626 People Helped

How do you remove the windshield wiper arms

Have 87 Chevy S10. How do you remove the windshield wiper arms? Need to remove the bolt on the backside of the wiper motor to replace it but cant get in the firewall. Need to remove the wiper arms and then the grill below them.

Posted by on

Answer

  • Most Helpful of 1 Answers

The wiper arms have a push in tab at the very bottom at the fitting that is pressed into the wiper linkage below the screen. Use a flat headed screwdriver to pry out the tab. Once out the arm can be pulled right off. Now you can remove the cowling screen

Posted on Apr 07, 2010

Question

  • 3,991 People Helped

I need a diagram for the serpentine belt for a

I need a diagram for the serpentine belt for a 2.8L engine in a 89 S10. Searching this site I see that some genius said that you should "look under the hood". I looked - no help. I NEED A DIAGRAM. Anyone have one?

Posted by on

Answer

  • Most Helpful of 1 Answers

Depending on how your vehicle is equipped will determine the belt routing, see attached.

No power steering or AC
91stt_5.jpg

With power steering
91stt_6.jpg

With power steering and AC
91stt_7.jpg

Posted on Nov 12, 2010

Question

  • 5,941 People Helped

i need fuse panel diagram for 1987 chevy s10

i need fuse panel diagram for 1987 chevy s10

Posted by on

Answer

  • Most Helpful of 1 Answers

This will help.

Posted on Jan 28, 2011

Question

  • 3,031 People Helped

I need a heater control vacuum line diagram

the blower motor was replaced and then I couldn't get the hot air to come into the cab. It blows hot air but the doors diverting the air to defrost, panel or floor, will not open to allow the air into cab. I need the vacuum line diagram to find which is broken or disconnected so it will divert air.

Posted by on

Answer

  • Most Helpful of 1 Answers

87 s10 vac diagram hvac-n1newilcda0k1bnfel1uu15c-1-0.jpg Does that help?

Posted on Jan 14, 2018

Question

  • 2,067 People Helped

does a 1985 chevy s10 have fuse for fuel pump or throttle body and were are they

New fuel pump no power to fuel pump wire but do have power to fuel level side

Posted by on

Answer

  • Most Helpful of 1 Answers

Yes it does, and also a fuel pump relay controlled by the ECM or PCM.
Can be either problem.

Posted on Mar 05, 2013

460 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

1987 Chevrolet S-10 Pickup S 10

  • 1987 Chevrolet S-10 Pickup S 10

Most Popular Question

1987 chevy s10 2 8 spark module color

  • Cars & Trucks
Loading...