20 Most Recent 1987 Chevrolet S-10 Pickup - Page 4 Questions & Answers

The decal under the hood is the best place to look for the specific instructions, but depending on which engine you have you will need to disconnect a wire terminal, and then set the timing as usual with a timing light. The decal usually gives the connector location and wire color. If not what engine do you have?

place cylinder 1 end of compression ,timing mark to 0 then remove distributor cap and the rotor should point to number 1 cylinder wire and you go firing order the way the rotor turning

Check your E.mailThat was answeredGoogle the codes you getOBD 1 code 22 if a pre1996Otherwise OBD 22

This will help.

behind glovebox.

you have to reset base idle see manual at library for procedure

Yes it does, and also a fuel pump relay controlled by the ECM or PCM.Can be either problem.

check fusible links by the starter in the power wires

check for a ground wire left off if it is not a starter prblem if so check wires on starter and battery ground to eng.

relace the throtle air idle valve.The temp switch will allso cause this problem.

bad ignition switch, not the ignition cylinder, ignition switch or starter soloined.

I am sorry we have no such diagrams here. You can access them at the local GM dealer parts dept, just show them the general area and they can bring up the diagrams that show all the parts and you can then point it out to the parts tech.