20 Most Recent
1988 Chevrolet C2500 Questions & Answers
Replacing gear shift cable
Should be located on the Drivers side of the Transmission close to the Floorboard from underneath the vehicle.
Need diagram for how to put a serpentine on a 1988 C2500
start at the bottom crank shaft.Then on backside of belt you go around the rite side of fan then around the top of air conditioner ,to the bottom of water pumpto the top of alternator,using a socket on the tensioner (to get it over the alternator)
Speed sensor
On the passenger side of the transmission.On the side closer to the rear of the tranny
No headlights
Sounds like a defective healight switch. they are cheap and it is a good guess.
My 88 chevy 2500 3/4 ton runs, but when given gas
check your fuel filter under the left side of the vehicle on the frame. if this proves to good, your next step might be checking your catalytic convertor. have you checked all of your vacuum lines? one thing you can do is have your friend inside to start the vehicle and while it is idling and the air cleaner is off, look inside at the fuel injector and you throttle it and see if the injector is spraying fuel.
1988 chevy pick up truck speed not working
These are run by a module on your trans now. It is the same one that shifts the truck. They are kind of expencive to replace. You will see it on the driverside of you truck on the side of the trans. There is going to be two that you will see it is going to be the inside one that runs the speedo.
Have to pump gas to start
Check your fuel pressure it should be 9-13 psi with key on and engine off.If its not within these specs then replace the fuel pump and filter.
No power to the fuel
Hi, Check fuse in fuse box, usually marked fuel pump. Also check that relays are good. Good luck.
Hi the tansmission is slipping in drive and
700r4 is pretty easy to rebuild. It likley burned up the 3-4 clutch pack. If you intend to rebuild it yourself, ebay is a great source to buy the kits. Make sure you look through it and get clutchs, steels, band, filter and bushings. Almost every kit comes with the seal kits. You should also put a new reaction sun shell in as they commonly break. It's less than $200 for all this and fluid.
Not finding what you are looking for?