20 Most Recent
2000 Chevrolet Silverado 2500 - Page 5 Questions & Answers
Truck wont start...
have battery load tested at local parts store ( it will
need to be fully charged )
hope2help shack
Fuel Sending unit on a 2000 Chevy Silverado
if it is the fuel level sending unit you will have to replace the pump because they are a 1 piece assambly. it will be a task to change too as you will need to either remove the truck bed or drop the fuel tank to get to it.
Truck stalled and won't start
sounds like the crank sensor if you have fuel do you have a fuel gauge it should be about 70-110 psi on the fuel rail
Ticking Noise in 01 Chevy Silverado 2500
if noise is higher pitched and coming in on valve time...(2wice for every revolution of motor..ie: faster)...then upper end pressure is down due to sludge, wear , lifter failure, valvespring failure,rocker stud lifting out of cylinder head (kinda common) cam bearings failing (very rare)..oil pump bypass stuck open..and a few other possibilities... respond and we will go over lower end sound (deeper ,slower) and see what identifies your issues .... miles
Where is the turn signal relay located on a 2015 Chevrolet Silverado 2500 he
Doesn't use a flasher relay , computer controlled .
Turn Signal/Hazard Lamps
When the turn signal switch is placed in either the left or right position, a ground signal is completed from the turn signal switch to the BCM. When the hazard flasher switch is activated, a ground signal is completed from the turn signal/hazard switch to the BCM. The BCM then sends an ON-OFF voltage signal through the fuses to the appropriate turn signal and side repeater (export only) lamps or to all of the turn signal fuses for hazard operation. The driver door switch and passenger door switch also receive voltage from the BCM turn signal supply voltage circuits for the mirror turn signals. The door switches have no function or control of the mirror turn signals other than a pass through connection for the circuits. The audio chime is also activated when the turn signals are ON. The instrument panel cluster (IPC) receives the signals to activate the turn signal indicators over the GMLAN serial data system. When the hazard switch is pressed, all turn signal lamps will flash including both IPC turn indicators.
7/13/2022 12:34:52 AM •
Chevrolet...
•
Answered
on Jul 13, 2022
1997 Chevy Silverado 2500 idles fast
Probably a vacuum leak at the intake manifold. You can spray
carb cleaner around the edge of the manifold and the throttle body
to find the area where the o-ring is leaking.
2/26/2019 9:23:47 AM •
Chevrolet...
•
Answered
on Feb 26, 2019
NO tail lights at night on chevy silverado 2500 hd, 2003 chevy silverado 2500hd, changed oem tail lights to LED tail lights, now I have the following problem: brake lights work, reverse lights work, t
https://postimg.org/image/3z4st152t/
Click on the link.
Did you check the park fuses, note the diagram, rr and lr. Use a test light to check voltage at fuse circuit, headlamp switch on. That should tell us if problem is before the fuse or after.
You always want to check voltage and ground circuits, for lamps. Do the front park lamps work?
2/26/2018 3:17:11 PM •
Chevrolet...
•
Answered
on Feb 26, 2018
Not finding what you are looking for?