20 Most Recent
1991 Chevrolet S-10 - Page 3 Questions & Answers
What doesbrake light switch look like
ok look under your dash where your brake pedal is the little switch there that is it when you push your brake the switch comes out turning the lights on when you let go of the brake the switch goes in turning the lights off..
Why is my 91 s-10 4.3 idling high
check for vaccum leaks on intake manifold. follow brake booster hose to engine and check for leak from there. Also check idle air control (IAC) this is what controls idling on todays vehicles. the IAC may be plugged, sticking, or bad. remove and clean if possible. Hope this helps!
Where is the oil filter on a 1991 chevy s10 pickup?
My 1991 s-10 blazer with a 4.3 v-6 had the oil filter mounted under the hood behind the left headlight...there will be two lines that come from the block to the remote filter located there....hope this helps....Larry
My oil dipstick tube broke off how do i fix this
For most chev they are pressed into the block and then there is a piece with a nut that screws on somewhere to keep it steady. If it broke at the base where it is pressed in, my advice is get a very slim hard pick, and pry it around the edge until you can bend in the outer edge of the remaining tube. once that starts to fold, get some needle nose pliers and push it into itself more and it will just pop out. A new one will push in just fine, make sure you screw in the arm that holds it in place or you will replacing another one.
How to replace oil dipstick
If the handle is broke off and you can't pull it out. take 1/8 inch drill bit,drill a hole downward into the piece that is still in there.Take a sheetmetal screw,screw it in a little.Then pull it out.Hope this helps!
Not finding what you are looking for?