1994 Chevrolet S-10 - Answered Questions & Fixed issues

It sounds like there may be a problem with the transfer case of your 1994 S10 4x4. The transfer case is responsible for transferring power from the transmission to the front and rear axles, and it allows you to switch between 2-wheel drive (2H) and 4-wheel drive (4H and 4L). If the transfer case is not functioning properly, it can cause the truck to behave as if it is stuck in 4-wheel drive, even when the lever is moved to a different position. There are several potential causes for this issue, including a faulty transfer case control module, a damaged transfer case shift motor, or a problem with the transfer case shift linkage. In order to determine the root cause of the problem, it will be necessary to have the truck inspected by a mechanic. They will be able to diagnose the issue and recommend the necessary repairs.

weak fuel pump have fuel pressure checked

Question edited for clarity. Question moved to correct model category. You need an auto electrician with a pro grade scan tool computer to diagnose the charging circuit and battery drain. https://www.google.com/search?q=auto+electrician+near+me ..

Sounds like you have an issue with the engine temperature switch for the ECU keeping the engine in phase lock one it's warmed up. a scan tool that's able to acccess OBD 1 live stream data would verrify this.

need wiring diagrams on4.3 1994 s10 chevy pickupspark plug wires

On 4.3 what does second pass 75° mean?

LOOK UNDER YOUR TRUCK DO YOU HAVE TWO DRIVE SHAFTS IF ONLY ONE (2) WHEEL DRIVE

out of time ?

you have a heat controlled actuator, go to posilok .com they sell a manual actuator

did it shift before the new clutch?

So, injectors are not firing, right? Is there power on the pink injector wire? If you put an ac voltmeter on any of the injector connectors while cranking, do you see ac voltage?

normally the ECU gets the message from the pressure regulator unit , tells the ECU when pressure in the fuel rail is reached and the pump is not needed until pressure falls below a preset level

check to make sure the catylitic converter is not clogged.

Check the fluid level & colour, if it's low or burnt it will cause problems, it may also be the seals which will require transmission removal & overhaul

60--66 psi. In my opinion. After it starts, it should run with less pressure.

I had the same problem - driver side fine, passenger side front not working/slow or the back seat. You need to replace the window motor on the passenger side. Yes, there are two motors. It's pretty simple if you are handy with some tools. The hardest part is getting the 4 mounts that hold the window motor to the door off. The are factory riveted to the door, so I had to grind the outsides off and tap them out. Just watch the spring lever that holds the window bar for going up and down. I didn't pay attention and it snapped back - nearly broke my thumb.

Dani-Lynn

Pull the fuse out.

hi, from what you stated it sounds like you have a major internal failure and the transmission needs to be overhauled or replaced. you should take it to a trans shop and let them check it out before any more repairs are attempted. sorry for the bad news. dave

Hi Devin, The link below is a short youtube video showing how to test and fix a car that shuts off randomly, Hope this helps.....CHEERS.. https://www.youtube.com/watch?v=oBo-vmEEwv4 Fixing Car That Shuts Off Randomly

The cat converter might be plugged?