1997 Chevrolet Blazer - Answered Questions & Fixed issues
No gas coming out the injector and there is gas
Is there an injector pulse going to the injector?(an electrical pulse to fire the injector).
Is there spark at the plugs?
If the pickup in the dist is faulty you won't have either one.
If your vehicle uses a crank pickup with or instead of dist pick up....if it is defective ....no pulse.
The above is 90% cause of no pulse....other is computer problem 10%.
If you do have a injector pulse and no spray.....and have fuel pressure....change the injector.
A quick check for spark is spray a little starting fluid in it.....if it starts on the fluid....spark is present.
My 1997 chevy blazer failed
The OBDII / OBD2 connector is 18" from the center of the center console.
You will need to purchase an OBDII scanner/reader to read these codes.
The alternative method is get a OBD2 cable and a laptop + software to pull the codes.
===
An inexpensive OBD2/CAN bus reader around $75-$120 is a good start.
===
Did the inspector mention anything about drive cycle or lack of stored readyness fields?
Please email on why it fail. You can append more info by click the button on TOP RIGHT of this page.
I have '97 chevy blazer.
None of these things are related there all separate issues.
The window problem is in the door control master switch . the abs could be a wheel speed sensor vary likely and the blower motor could be an accuator or a bad vacuum switch or a bad connection at the blower motor or the resistors .
97 Chevrolet blazer, have code ignition coil 1-4
My personal suggestion would be to go for these repair catalogs. I know this website reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.
97 blazer 4x4
Had an issue similar to this with a customer astro van. It was the front differential that destroyed itself. We took the front driveshaft off and he drove it like that for a while. Then sold it. So, I am not sure what happened inside that front axle, but is was locked up. As long as we took off the driveshaft, the spider gears were the only thing spinning internally. So it could be driven again.
Blower switch on 98 s10 has no power but the fuse does
Do you know what a splice in a wiring harness is ? Looking at a wiring diagram for the heater / A/C controller . I see S221 ,may have a break in the wire right there . Look here
http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model , an engine size . Under system click on HVAC , then under subsystem click on HVAC control's ,then click the search button ,then the first blue link . Scroll down to the thrid diagram. If you had factory service info. you could find the location of that splice .
Car stuck in park & wont shift at all.
There is probably a safety interlock with the brake pedal so in order to move from park the ignition must be switched on and the footbrake applied.
I suggest you read the section in the vehicle handbook and if there is such an interlock and it isn't working check the brake pedal switch function and adjustment first.
Not finding what you are looking for?