20 Most Recent 2006 Pontiac G6 Questions & Answers

The fuel composition sensor goes by several other names: flex fuel sensor, fuel compensation sensor, and variable fuel sensor. Its exact location varies according to the vehicle's make and model, but you can usually find it in the fuel line that connects the fuel tank and the injectors This for flex fuel models not sure Pontiac had it.

Question edited for a lot more clarity. Question moved to model category. It is a known issue on that model. Check out the forums. https://www.google.com/search?q=2006+Pontiac+G6.+It+is+stuck+in+park ..

check the oil and coolant levels. if coolant is low pull the sparkplugs and try to turn the engine over if still not turning free remove the serpentine belt and try again, if it turns over ok check the pullyes on the front of the motor to see if they all turn free by hand. a serpentine belt can prevent an engine from turning over if a tensioner, idler, water pump, alternator, or power steering pump is siezed up or starting to seize. being your battery is bad I'm thinking probably the alternator is seized. hope this helps mike.

Question edited for clarity and add some CAPS.Question moved to model category.In this link and also videos on replacing the serpentine belt on the G6.https://www.google.com/search?q=2006+pontiac+g6+serpentine+belt+diagram.

I always buy a service manual from advance or some parts supplier for every vehicle I own, that way the manual tells me how the parts are mounted to the motor and their location to the rest of the motor. I am not sure where the starter is located on a Pontiac G6 but look above it if you have to use a flashlight, if your oil filter is near it, make sure it is tight and not loose. Sometimes valve pan gaskets leak and run down the side of motor making us believe oil is coming from another place, just start looking and you will find it.

it is located on the passengerside under the altenator closest to the firewall. make sure the vehicle is turned off reach in under the altenator and you should feel the cap.

Sound like something has fallen into the motor (small tree branch,pencil,etc. Remove heater motor .Be carfull.You might find something unexpected!

You probably need to do a key relearn procedure. Turn the key to the ON position for 15-20 minutes until the security light goes out. Then turn the key off and back on again until the security light goes out. You need to repeat this 3 times, then once again turn the key off and back on, this time the security light should light and go out after its 3 second check. Now the car should start normally.

It seems like you need to reprogram your key, and this is how you can do it: 1. Sit in your car and ensure all doors are closed 2. Put the key into the ignition while holding the lock button on the driver's door 3. Turn the G6 key in your ignition from "On" to "Off" while holding the "Lock" button, and do two more cycles of "On" and "Off" in quick succession. 4. Release the ock button and press and hold the lock button on the remote for 15 seconds 5. Now, remove the key from the ignition, and it should be programmed, and anti-theft mode would be put to rest

generic help and parts in the link https://www.google.com/search?q=2006+Pontiac+G6.+How+to+replace+trunk+lock+cylinder ..

That sounds like an ABS Sensor issue. Connect to a high level scan tool and look at the ABS Data.

solenoid in inside the transmission side cover. You must drop the engine cradle and lower transmission about 8-10 inch's to remove. just did one yesterday took about 4 hr .

The battery cable trick is the oldest shitiest trick in the book it solves nothing but delaying a problem and erasing the ck engine light.... I've been up and down the Pontiac G6 from no start no crank issues to climate control to pc problems these cars have way to many issues that should have been recalled of course the reason these things weren't recalled is bc GM would owe some of you guys a new car. I can help with about any G6 problem but some things aren't worth fixing

may happen when the system senses some weight on the passenger seat (dog, etc) or the weight switch is faulty/stuck. You can verify if this is the reason if the passenger airbag notice light shows ON.

You might want to read the article at the link below. It might save you some time and trouble if you are trying to figure out a problem with your trunk release system.Where's The Fuse?Then, to answer the question you asked, the trunk release circuit is protected by the "TRUNK" fuse. It is Fuse #22 (10 Amp) located in the Rear Fuse Block in the left side of the rear compartment, behind the left rear wheel well.

What are the torque specs caliper bracket bolts and pins and axle bolt pontiac g6 2008

depends on what radio you have if it is fitted to the radio. some are others there is a compartment near to the radio that is for the gps. you will find it by looking were the signal line is on the window or roof depending on model.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

This is a full day job with about 25 steps. Nobody is going to sit here and type it all out for you. This is where you really need a shop manual with diagrams and torque specs. Check with your public library to see if they have one for free online. Don't do this job without a manual and diagrams.

Well some auto part place will allow you to use the tools. You have to pay a deposit which is usually the price of the tool but when you bring the tool back they will give you the money back. Just for the heck of it I pulled up ball joint for 06 Pontiac G6 and it gave me replacement part lower control arm. https://www.youtube.com/watch?v=D-SoyYCz0qw https://www.youtube.com/watch?v=gjQxxUcXRLo https://www.youtube.com/watch?v=E9O_cOB2MTI The link below refers to the control arm needs to be replaced. https://www.g6ownersclub.com/forum/12-problems-solutions/9736-has-anyone-replaced-front-lower-control-arm.html https://www.g6ownersclub.com/forum/13-general-maintenance/34218-worn-ball-joints.html