20 Most Recent
2007 Kia Rondo LX V6 Questions & Answers
2007 Kia rondo interior lights stay on when headlights turned on
I had the same problem for months. Finally took it to the dealer. The first time, they diagnosed is as a short in the rear interior bulb, and put in a new bulb. Got it home and still had the same problem.
The second time in, they figured things out. On the dash to the left of the steering wheel is a knob that controls the brightness of the dash lights. But, if this knob is all the way on, it turns on the interior lights and keeps them on. Just had to turn this knob down, and the problem was solved!
How do i release the
The spare tire is located under the car just in front of the rear bumper. Here's how to remove it:
1. There should be a liftgate on top, open it then locate the U-shaped slits in the carpet and then remove the carpet, and you will see the hex nut
2. Use a lug nut wrench to unwind the hex nut
3. Turn counterclockwise until the tire is lowered to the floor below
4. Remove the retainer, and that is it
My A/C unit was working fine maybe needed a little
Depending on how low your system was , If you only charged with one can , this may not have been enough. Try a second can and listen for the clicking to go away. The clicking is your compressor engaging. Safety suggestion rap the can with a small towel and shake can while Freon goes into your system. Good Luck Friend.
I just attempted to replace
a desconected relay will not drain the battery, you might have some other issue. start the car using boost and then check if your alternator is charging around 14 volts
Emmisions system purge valve
The carbon canister and the purge valve are located in the rear of the vehicle just behind/below the fuel tank
below the filler hose
How to reset check engine light
You can either use a scan tool/ code reader to erase it, disconnect the battery for 5 mins, or go to an advance to have them do it.
How do I replace a brake light switch on my 2007 kia rondo?
It's located on the brake pedal. you'll need a 14mm wrench. There are 2 14mm nuts that sandwich the switch to the bracket. take the bottom nut off and the switch will come off. Install reverse of removal but you need to adjust the switch depth once its on the bracket. then snug the bottom nut and plug in the switch.
Not finding what you are looking for?