20 Most Recent
2006 Chevrolet Impala SS Questions & Answers
Why do doors unlock but can't be locked?
Professional Auto-Tech Expert writes
- Jeff Armer Mar 29, 2022
- Won't lock ? power door locks ? with key fob,door switches ? more info.
-
Jeff Armer Mar 29, 2022
Power locks are controlled by door modules and BCM, hook up a scan tool an check for codes .
-
Jeff Armer Mar 29, 2022
Could be door lock relay problem .
DTC B3125
Circuit/System Description
When the door lock switch is place in to the LOCK position, ground is applied through the switch to the body control module (BCM). The BCM then applies a voltage through the door lock relay control circuit to the coil side of the lock relay in the body electrical center (BEC). The relay then engages and applies voltage to all the door lock assemblies.
DTC B3135 00: All Door Lock Circuit
..
Where is the camshaft position sensor located on a 2006 impala ss
If you have the SS remove the fues panel cover and take the two nuts off at the top of the pannle lift it up and look under it you will see the thin wiring harness running down between the strut tower and the behind the serpentine belt follow it down to a plug-in lift to unplug the clip and you will find the cam position sensor there is one 8mm screw holding in place. Remove that screw wiggle the cam position sensor left and right and it will pull out replace it with a new one and reverse the procedure. The car will crank but not start if this part is bad.
Impala ss Firing Order and Cylinder Numbering 5.3L
I think the firing order on any GM V-8 is 1-8-4-3-6-5-7-2, #1 being the front cylinder on the drivers side and #2 will be the front one on the passenger side, then back to the drivers side for #3 and so on.
Not finding what you are looking for?