20 Most Recent 2005 Chevrolet Colorado Extended Questions & Answers

Your owners manual should have this info. If your having a problem with particular system? I'll try to help. If you don't have an owners manual, you can go to my.gm.com The last time I was there, you had to register your vehicle, but, it's all free. Follow the links to find owners manual. Try the link. https://my.chevrolet.com/content/dam/gmownercenter/gmna/dynamic/manuals/2005/chevrolet/colorado/2005_chevrolet_colorado_owners.pdf

Dead wiper motor. Or very bad wire connection. Or possibly bad relay after fuse, and before wiper motor. You can test motor by a direct jumper from positive to the motor's positive terminal.

every time you disconnect the battery you corrupt the CPU program in the ECM try using a scanner to reset the ECM

Your owners manual should have this info. My info for ac delco says 41-981.

CHECK AND SEE IF THE FUEL PUMP FUSE OR RELAY IS BAD.

Question edited for clarity and spelling. Question moved to model category. The most likely reason is the reversing light switch which is located on the transmission. https://www.google.com/search?q=2013+chevy+colorado+reversing+light+switch ..

All in the link https://www.google.com/search?q=Chevy+Colorado+IAT+location ..

under dash behind glove box

Hello. Twist the headlamp socket counterclockwise (to the left) to remove it from the headlamp lens; clockwise to install. The headlamp 'capsule' 'pushes in' 'pulls out' socket. It's held in the socket with a 'lift up' clasp. Good luck and keep me informed; if you want to.

Call any dealership, they have to tell you truthfully if so

It should be behind the glove compartment, squeeze the sides of door and let it hang down, Look uo and to the right side and you'll see the mode door, just to the right side of the the door will be the actuator motor Hope this helps

Get your cell mate to remove it because if you do you will be charged with a Felony for tampering with mortgaged property.

35 foot pounds the thing is go over them a day later after gasket settles

OBD code P069E is pointing towards the fuel pump control module CIRCUIT. check all connections

Fuse box under hood in engine bay TBC fuse 10 amp , TRN HAZRD REAR fuse 15 amp an TRNHAZRD FRT fuse also a 15 amp.

put park brake on, turn ignition key to on position (no start) turn parklights off and on 4 times quickly (horn should sound twice). If you have or can get a TPMS activation reset tool great. Starting at drivers front, then passenger front, then passenger rear, then drivers rear. if you do not have a reset tool then you can try following method. Take valve caps off of all tires, start at drivers front tire (front left) let out 2 to 3 psi of air, about 5 seconds (TPS will detect this) wait about 10 to 15 seconds for horn to sound proceed to passenger front (front right) and repeat process, proceed to passenger rear and repeat process, proceed to drivers rear and repeat process. If horn does not sound than you will have to turn ignition key off and start over. You may have to re-inflate tires, it took me 2 days of @#$&^# around to get this method to work first time. God help you if a sensor is bad or missing.

Black smoke is usually unburnt fuel. I would check the lambda sensors in the exhaust.