20 Most Recent 2008 Dodge Ram Pickup 2500 Questions & Answers

$7E8 and $7E9 are sub menus for the Engine and Transmission. You need to select one and press enter. It will then give you the code for that sub menu.

get outa here power choke when your sittin on the side of the road ill haul you your payload and mine if your front bumper dont fall off cummins is right there in power with 2 less cylinders get better mileage and are more reliable and if you want more than that ill bring a v10 VW toureg with 550 lbs at stock software levels CAPABLE OF OVER 1000 LBS

You need to take it in and have it scanned for fault codes, that is the first step in repair of this problem.

A Simple Preliminary Car Starting Procedure If your car won't start, try this procedure:

• Check the battery cable connections:

Make sure the positive cable, makes a good connection at the battery and at the starter. Make sure the negative cable makes a good ground connection at the battery and (preferably) at the engine.

• Check the battery the simple way, like this:

Turn on the headlights, then try to start the car.If the headlights do not dim or go out, then the battery is likely ok.

• Check the starter and solenoid:

If the wiring looks ok, then look at the starter solenoid for a good connection, and proper voltage at the starter(10 volts minimum while cranking). If the starter spins and no crank, the problem is most likely the Solenoid's bendix gear is stuck. Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck bendix gear.

Look to see if the wires for the seat belts are attached to the seat. Usually thy are plastic clips that push into a hole in the metal frame.

p0303=misfire on cyl 3
p0513=incorrect immobilizer key
p2503=charging system voltage low
p063d=charging system voltage high
p2509=PCM input signal intermittent
have a dealer check this one,it could be anything from the ignition to a alternator failing

Seen where?, point and tell. on the VFD .cluster display? get it scanned, scan the PCM for more errors. C codes are chassis codes, in my FSM book. but my car dont have your code. listed. its only used in your car. so get the fsm and look you your code, or alldata.com might have it. the FSM for sure.