20 Most Recent 2009 Chevrolet Aveo - Page 6 Questions & Answers

You have to replace the headlight bulbs. There are two elements in each bulb one for low beam and both for high beam. The low beam burns out first...

pinhole or small crack in the fuel line or gas tank

Confused!. how do you know that the starter is good, if the vehicle engine will not turn over?.... Do you mean that the Starter will crank but the engine will not turn over?. If the later is the case then you will have to look a bit deeper it could be your Fly Wheel with flat spot or not likely but possible Starter solenoid not fully engaging the starter to the fly wheel. Is your vehicle an automatic or Standard. If it is a standard then you could try to move the vehicle forward or reverse while in gear just a little and try to start again if the vehicle Starts then you have just verify that you have a faulty flywheel If you mean that the starter does not turn then you may want to look at your starter relay switch and or your neutral safety switch.

Code 12 is for a problem with the cam timing, and code 26 is for a problem with the intake valve control solenoid being out of range. The cam timing would need to be checked along with the control solenoid.

Raise tire pressure to 36psi, install a high air flow ( low restriction/low micron) air filter, and 5/20 full synthetic motor oil. And if you use a/c, set to normal or economy, not max. Also , most states use winter fuel which reduces fuel mileage 10 -15% on most cars.

run fault codes and look for a TCM fault.

make sure it hasn't broken off a piece that will make it out of balance

code po171 in chevrolate aveo 2010

it look like you lose the ignition current at clock radiocheck all fuses

it's normal to see no power when engine over heating try to see coolant level and change the thermostathave radiator cap check

axles and bushings are two totally different things. when you say bushings I think of upper and lower control arms that have bushing pressed in by machines that can be pressed out the old ones and press in the new bushings. Axles I think of constant velocity joints and boots which also can be replace with new ones.please tell me what you are asking?