Sal De

All Activity

• 

  Sal De posted an answer for this GE Ovens:

  "f3 is a shorted sensor and f5 is a bad computer board or clock assy. same..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Ovens:

  "i don't understand what you're asking and you have to send the model number off of the..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Jenn-Air Ovens:

  "whenever you set an oven it always starts at 100,if that's an electric oven most likely..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Kenmore Dryers:

  "yes,unplug it,get a putty knife and slide it under the top control panel on each..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dryers:

  "if that's an electric dryer that runs on 240 volt and that's why that cord is on it you..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Maytag Dryers:

  "http://homeguides.sfgate.com/replace-broken-baffles-frontloading-washing-machine-104577.ht..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De wrote a tip for Dryers:

  "Once the temperature drops the operating/control thermostat will close and complete the..."

  • Sal De
  • Over a year ago
  • Go to tip page »
• 
  Sal De Commented on an answer to the question about Maytag Neptune MDG5500AW Gas Dryer. Over a year ago
• 
  Sal De Commented on an answer to the question about Maytag Neptune MDG5500AW Gas Dryer. Over a year ago
• 

  Sal De posted an answer for this Ovens:

  "http://www.applianceaid.com/newer-frigidaire-fault-codes.php it says the problem is the ..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Kenmore Ovens:

  "that model doesn't come up,that could be the serial number,do you know that when the dryer..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dryers:

  "first off what's the brand name and model number?if you have 240 volts to the dryer,and..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Kenmore 24 in. 15689 Built-in Dishwasher:

  "If the clean light flashes 7 times it's an error code telling you that there's a heat..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Kenmore Dishwashers:

  "If the clean light flashes 7 times it's an error code telling you that there's a heat..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Kenmore Dishwashers:

  "there's a thermal fuse that can pop if it won't run or no lights,if you have power in the..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher:

  "if the light is flashing 7 times there's a heat problem and the dishwasher won't start,if..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dishwashers:

  "remove the bottom kick panel,you'll see a tech sheet there in the plastic bag,it will tell..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dishwashers:

  "yes you reset the board but after like 7 loads it's gonna do it again,that's an error..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dishwashers:

  "the flashing light is an error code,you either have a bad heater or the board is bad,once..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher:

  "even though you reset the board the flashing light is an error code,you either have a bad..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this KitchenAid 24 in. KUDP01FL Built-in Dishwasher:

  "if it ran for 2 minutes most likely it went into cancel drain just like when you hit the..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this LG DLE2101 Electric Dryer:

  "you can buy a new block and you don't have to replace the whole harness if the wire just..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dryers:

  "why,what's wrong with the door that it doesn't close,i mean is it not locking,is the door..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this GE Dryers:

  "your gonna have to go deeper than the door switch,do you know you can't get the blower..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Electrolux Dryers:

  "these machines have alot of computer board issues,unplug the dryer,go in the back where..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Dryers:

  "anything is possible,if you have a gas dryer and at first you have heat and then no heat..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Maytag Dryers:

  "this is an electric dryer,first thing to do is on the back where the cord connects to the..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 

  Sal De posted an answer for this Whirlpool Dryers:

  "that could be a few different things ,broken belt,there's a switch on the belt pulley that..."

  • Sal De
  • Over a year ago
  • Go to answer page »
• 
  Sal De Commented on an answer to the question about GE Profile Harmony DPGT750EC Electric Dryer. Over a year ago
• 
  Sal De Commented on an answer to the question about GE Profile Harmony DPGT750EC Electric Dryer. Over a year ago

Load more activity...