Yamaha VK Professional - Recent Questions, Troubleshooting & Support
Ignition wont work on a vk professional
Check your fuses. use a ohm meter.
use a test light to see if you have power to your ignition switch.
if not check your relays.
if you have power to your switch turn it to the on position, see if you have power there. If you have power there, then turn it to the start position,see if there is power there. if not replace switch.
Hope this helps.
.
10/11/2014 11:30:04 PM •
Yamaha VK...
•
Answered
on Oct 11, 2014
2007 vk professional running hot,engine light on,codes 21,84 on
I have the book but I cant find the codes.
So find out if your rad fan is coming on. If it does then pull out your thermostat and place it in a pot of water and see at what temp it opens at. The open temp should be stamped on the thermostat.
If it is stuck closed or opening to slow, replace stat.
Good luck!
How to adjust gear chain on Yamaha VK pro
Locate chain tension bolt.
Loosen locknut.
With 2 fingers tighten the lock bolt until it is tight.(not crazy tight)
Then back off the lock bolt 1/4 of a turn.
Hold bolt and tighten lock nut.
You are done now.
Good luck!
Running hot
I need a bit more info.
What is the strength of your coolant?
Does your rad fan come on?
When, and what type of conditions does this happen?
Replacing starter
The Starter is located forward of the Engine, Left side. Make sure you disconnect the Battery BEFORE you start working on the starter.
How to remove a gas tank on Yamaha Apex 2007
You have to remove the 2 bolts holding the seat down under the tunnel first. Then slide the seat to the rear to remove it.
Then you can remove the springs holding the hold-down plate on the rear of the tank. Just slide the tank back then.
Not finding what you are looking for?