Yamaha Apex XTX - Recent Questions, Troubleshooting & Support

0helpful
1answer

Hi my 2014 Yamaha sr viper is very hard to start cold or hot

Is it getting enough fuel? Have you replaced the fuel filter and or air filter? If either or both are dirty or restricted it could cause hard starting and poor performance. Have you checked the solenoid wire on top of the battery? Try removing cleaning and re-installing solenoid wire and battery cables. Also have your battery tested. Just because it is turning the engine over does not mean it is spinning fast enough to start. A weak battery can also cause damage to your starter.
3/26/2019 12:31:56 PM • 2014 SR Viper... • Answered on Mar 26, 2019
0helpful
1answer

What would be the reason code p0118 is coming up?

cts coolant temperature sensor is malfunctioning
2/26/2019 12:26:55 AM • 2014 SR Viper... • Answered on Feb 26, 2019
0helpful
2answers

Fault codes on a 2014 viper the codes r po 122 120 and 522

Since it's a 2014, contact a Yamaha dealer.
1/6/2019 8:12:27 PM • 2014 SR Viper... • Answered on Jan 06, 2019
0helpful
2answers

Why does my 1999 Yamaha 250 bear tracker start up and then die automatically?

Sounds like a spark plug, then if its not that have the battery checked.
4/8/2015 11:11:07 PM • Grizzly Big Bear... • Answered on Apr 08, 2015
0helpful
1answer

How many spark plugs grizzly Yamaha 600 4x4 ATV nd where sides plugs

It's an xt600 engine with 1 cylinder so 1 spark plug, remove seat & fuel tank
2/16/2015 12:22:43 PM • Yamaha Vehicle... • Answered on Feb 16, 2015
0helpful
1answer

Engine oil capacities 2004 yamaha bruin

2.5 quarts
11/28/2014 6:05:38 PM • Grizzly Big Bear... • Answered on Nov 28, 2014
0helpful
1answer

Where is vin on 2004 yamaha bruin 350

It is located on the left frame rail below engine at front behind lower control arm...
11/28/2014 6:04:01 PM • Bruin Kodiac Atv... • Answered on Nov 28, 2014
0helpful
1answer
0helpful
1answer

How to replace starter relay on yamaha grizzly

Just raise the seat and find the relay located next to the battery, remove the to nuts holding the wires on and unplug the small harness, install new one and replace the seat
10/6/2014 4:11:31 PM • Grizzly Big Bear... • Answered on Oct 06, 2014
0helpful
1answer

How to install horn

power to switch then from switch to horn other side needs to be grounded usually marked pos neg
9/7/2014 3:53:32 PM • Grizzly Big Bear... • Answered on Sep 07, 2014
0helpful
1answer

Atv trouble shooting

Is there a separate fuse for the brake - tail light
8/14/2014 2:34:33 AM • Grizzly Big Bear... • Answered on Aug 14, 2014
0helpful
1answer

Hison jet ski

doesnt it have an oil tank and pump and manage its own mixing?
8/9/2014 1:35:19 PM • 2-cycle Engine... • Answered on Aug 09, 2014
0helpful
1answer

What is the valve spects on my 2000 yamaha big bear 400

See hand book under spec's
7/29/2014 11:57:12 PM • Grizzly Big Bear... • Answered on Jul 29, 2014
0helpful
1answer

Where to find battery for 2009 LAND ROVER lr2

Halfords is a good place to go or your local independant motor mechanic
7/25/2014 10:57:43 AM • Grizzly Big Bear... • Answered on Jul 25, 2014
0helpful
1answer

Yamaha grizzly 660 shift linkage adjustment

Will it not go into park or will the light not come on? If it goes into park look at the switch. Check and make sure there is nothing binding the shift linkage or that the linkage is not bent. If all looks good adjust it. Adjust your shift linkage just enough for it to go into park. Then check engagement in other positions
5/16/2014 10:20:06 PM • Grizzly Big Bear... • Answered on May 16, 2014
0helpful
1answer

How to locate IAT sensor on 2009 yamaha grizzly 550

IAT stands for intake air temperature, the sensor is going to be located in the air snorkel tube/box air cleaner or the tube before the carb/throttle body (usually has 3 wires, reference voltage, ground, sensor output) Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/mike_a0891ab86974ea74
5/14/2014 2:59:55 AM • Grizzly Big Bear... • Answered on May 14, 2014
0helpful
1answer

I hve a 07 450 grizzly and the battery will not charge and have changed the stator and voltage regulator

Did you check the battery itself? It could be a dead cell or even a defective one. Hope this helps, when you get it figured out let me know please. Good luck! If you need further help, reach me via phone at https://www.6ya.com/expert/andrew_d2df42288260d96e
4/25/2014 6:11:08 AM • Grizzly Big Bear... • Answered on Apr 25, 2014
0helpful
1answer

Runs for 100 meters and then quits

sounds like a relay getting hot
4/5/2014 10:36:47 AM • Grizzly Big Bear... • Answered on Apr 05, 2014
Not finding what you are looking for?
Vehicle Parts & Accessories Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Yamaha Vehicle Parts & Accessories Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Yamaha Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Yamaha Vehicle Parts & Accessories

  • Forum

View Most Popular

  • Yamaha Vehicle Parts & Accessories
Loading...