Westinghouse Washing Machines - Recent Questions, Troubleshooting & Support

How many washing times and what is the minimum time

There appears for be a number of different types and not the 'electric skillet roaster' I was expecting. They must have pushed out past their fixings. https://www.google.com/search?q=Westinghouse+50%27s+era+electric+roaster ..

It is a lid switch issue. I has a magnet and a reed switch.

Westinghouse washing macjhine Lt608s goto start beeps & ...

JustAnswer https://www.justanswer.com > Australia Whitegoods Oct 23, 2012 - The 3 water level light does indicate the Out of balance switch as faulty, if it is accompanied by 15 beeps. 5 beeps means the lid switch = LD. 1 answer · Top answer: Hi Craig Lets not give up just yet. So you have replaced the out of balance s ..

Check the outlet pipe is not syphoning. If it is up above the drum height and free to the air, check for a foreign body, sand etc, in the water inlet solenoid.

Ld = all water level lisghts flashing slowly accompanied by 5 fast beeps every 4 minutes - LID is open position

got this out of machine manual hope it helps

check belt if ok check cogs under agitator then re calibrate unit

If the electricity does power off in the middle of washing cycles the washing machine will turn off then. Some of the most common problems that will make your washer turn off during mid cycle can include thermostat failure or issues filling up with water for the rinse cycles or even problems with the pump and the hose that can stop your washer from draining the water. You should call a person that fixes washing machines to have a look and see what the problem is with your washing machine.

Drum bearing problems and a water seal leaking would explain this. Open the door, reach in and grasp the inner tub, then lift and shake the inner tub to see if it has excess motion. It should remain tight and move with the outer tub only. If it is loose and moves, rattles or shakes then it is very likely that the inner tub has cracked or separated from the rear mounting (the spider mount) and would require replacement. The real issue is a either a broken spider mount and/or a bad bearing and seal. This is a difficult and expensive repair and not usually feasible. Another possibility (not likely, but possible) would be a clothing item caught between the inner and outer tub. This also requires fairly extensive disassembly.

pump blocked..... cheers

Please check it "SOLVED: Why won't my washer spin or drain?"

Contact White-Westinghouse to request it.

any appliance site or store will carry replace part requested

Check the drain line on the bottom rear of the freezer. It is either frozen over or has some sort of blockage.

Wait for any cycle to end completely

if you mess with it itll void any warranty..send it back

It does sound as if the machine is going out of balance. Perhaps you load too much in or there is not enough water entering the machine to spread the load.

top loader pull the center off the agitator and there is a lint filter at the bottom