Thule Boating - Recent Questions, Troubleshooting & Support
Chevy colorado wheel vibration above 40
if it is brake or drum related best take it to an accredited brake specialist shop for drum machining or disc skimming
it will take a proper diagnosis to determine what has to be done so get a quote
Thule Hullavator arm does not automatically lift as other arm does....seems to be leaking fluid?
Hullivator lift cylinders are pneumatic, there is no fluid to leak. However, they do fail, and when they do, they do not provide lift. Despite what Thule says, the cylinders can be replaced. I have replaced 4 of them. Drill out the rivets holding the old cylinders in place. I bought new cylinders from LiftSupportDepot.com - they were very helpful and they charged a little less than $30 each for the cylinders. The first cylinders were 75 pound lifts. Those my sister found too light to provide all the lift she wanted. I have since installed 150 pound lifts (this will require a clamp). I cut off, and reused, the longer of the original Thule rivets where the shorter rivet formerly was, and used a 5/16ths 4" stainless bolt in place of the longer rivet. It will take a couple of tries and some prying to get all the holes lined up for that last bolt, under pressure, but in retrospect it will all seem to have been surprisingly easy. Good luck.
Oil pressure problem on toyota rav 4
Disconnect the battery power. Take only one cable off the battery. Reattach it after 3 or4 minutes. That will reset the electrical and computer that controls the system.
What does p1044 on dodge dakota mean?
Try unhooking one of your battery cables. Wait 5 min and re-attach the cable. This will reset your computer and maybe the code will change or disappear altogether!
How do you assemble a
Be sure it is bolted together properly. Anything you tie to your roof should be very durable and well-built or it may find a new life as a KITE!
I have code po107 after clearing it it keeps coming back
code p0107 refers to manifold absolute pressure(MAP) sensor / barometric pressure (BARO) sensor --low input===causes --wiring short to ground --MAP sensor---BARO sensor ---ECM
check the wiring and connections to the MAP sensor
replace the MAP sensor
clear codes and run to see it the code comes back
if it does then replace the BARO sensor
Not finding what you are looking for?