Tappan Kitchen Ranges - Recent Questions, Troubleshooting & Support

The model doesn't appear to exist https://www.google.com/search?q=Tappan+TG0356BFW1 ..

Press the "Timer" button on your Tappan gas range 316071600 to turn off the timer. If that doesn't work, try pressing and holding the "Timer" button for 5-10 seconds. If neither of these steps work, try unplugging the range from the power outlet for a few minutes and then plugging it back in. If none of these steps work, it's possible that there is a problem with the timer itself. In that case, you may need to contact a professional repair service to diagnose and fix the issue.

This question also edited for clarity :>D Tappan are still in business and parts are available, BUT, this is a gas appliance and you are forbidden by law to try are repair it yourself. Get the part and and have a certified gas technician install it and do all the leak and safety checks. The ignitor only lights the flame, but that is likely NOT your issue. https://www.google.com/search?q=Tappan+72-3657 ..

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101



ssgs

There is no way to light the oven manually. The gas valve will not open until the oven ignitor draws enough current. But replacing the ignitor will fix ya up.

To replace the work light bulb on your Tappan 73-3951-23 over and under range, follow these steps:

1. Unplug the range or turn off the circuit breaker to disconnect power.
2. Locate the light cover shield on the underside of the range hood.
3. Press the clip on the left side of the cover and pull down to remove the shield.
4. Remove the light bulb by turning it counterclockwise.
5. Install a new 40-watt appliance bulb by turning it clockwise.
6. Replace the light cover shield by sliding it up into place until it clicks.
7. Plug in the range or turn on the circuit breaker to restore power.

Note: Be sure to use a 40-watt appliance bulb for replacement.

Hi, please double check that all of the wires or power cords on the unit have been plugged in properly. Then, you can power cycle your unit and check for these features to power on again. Thank you.

230 - 250volts AC only.

It is a Gas Stove. It can only be worked on by a registered gas technician who will supply and fit the parts. It looks like 'Revelation' is the model number. https://www.google.com/search?q=Tappan+Revelation+Gas+Stove ..

If you remove the display, you will see a capacitor on the back of the circuit board. That capacitor needs replacing.

A worn valve will leak. Get it replaced before you have an explosion.

You're better off just using elbow grease and cleaning it yourself

lots of help here including videos and instructions how to increase the size of the flame. https://www.google.com/search?q=light+the+pilot+light+on+a+signature+2000+Tappan+range ..

Try the manufacturers web site.

Free manual for similar model: https://www.searspartsdirect.com/manual/3ysks2epta-001269/tappan-tef351ews-electric-range

It could be the FSD(flame supervisery divice)not opening correctly starving the burner of gas.

spare parts are available in market..

https://www.partselect.com/Tappan-Range-Igniters.htm https://www.partselect.com/Tappan-Range-Igniters.htm if you've got your manual they have a customer service number

If you’ve given it time to cool down, the extreme heat from self cleaning may have damaged electronics Is the latch electronic or manual?

Replace clock / control