Russell Hobbs Blenders - Recent Questions, Troubleshooting & Support
Blender won't start at all, how can i even tell if the fuse is broken
There's a safety lock built into the handle of the jug. If the jug cover doesn't key into the lock properly, the motor base won't start.
Old blenders used to be able to start without putting the jug in place at all. I think this helps you know when the jug is in place properly.
It's indicated on the carton box; somehow I can't find my manual.
Cheers!
How do i take the bottom/blade off my Hobbs jar
are talking the blade inside the canister if so it unscrews from the clear handle and view area. otherwise if you mean the chuck below when the canister is lifted off that is held on by a fastener right in the middle dead center
How can I repair?
Your best bet is to open it up carefully and investigate. It's usually a minor problem unless it is old. Check it out yourself, you can't break something that's already broken and you'll gain some knowledge! :D
My blender leaks while I am making smoothie
Check to be sure your rubber gasket is clean and in the proper place which should be between the jug and the blade asembly. Also I have seen leaking when the assembly was tightened too much.
If you still have your receipt etc you may be able to exchange the unit where you purchased it. Alternatively contact the manufacturer and see if they can replace under warrenty
Not finding what you are looking for?