Powermatic Masonry Tools - Recent Questions, Troubleshooting & Support
I need to know how to adjust the blades on my
I usually adjust the knives slightly above the outfeed table. I use an aluminum straight edge & adjust them using a sheet of printer paper
on the outfeed table so that they are about the thickness of the paper
above the table. I place the paper on the outfeed table put the
straightedge on the paper & rotate & adjust each knife so they
just slightly hit the straightedge when I rotate the cutterhead by
hand.
Needless to say the jointer needs to be unplugged while doing
this.
Spindle on 8
Bite the bullet and take the blades out completely. If the blades are interfering, but you can't see where, you need a major blade reset anyway. And if the problem is not the blades, you would want to remove the blades to get at the problem (bearing?), just so you don't cut yourself anyway.
One of the ears on the yoke that lifts the infeed
Try these folks. They were formerly a Powermatic dealer and still have a number of parts on hand. I was in there yesterday and they are getting away from Powermatic and going exclusively to Sawstop.
J Redmond Wm And Son Inc
320 Coweta Industrial Parkway, Suites A&B Newnan,
GA 30265
-->
Snipe
could be the way you are feeding/removing the board. snipe is actually the sound the board makes when its end passes over the cutter. the inboard table should be slightly lower than the rear table. pressure and movement must be maintained when feeding the board the entire length of the joiner table.
Blade guard for Atlas 6'' jointer
I can send you pics of the one I made from plywood for this same jointer. If you're looking for an original I can't help you there.
Need a manual for a
If you're still interested, please see
this answer and follow the links.
I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!
Tuckpointing brick, mortar won't stay in. have a
is the recess deep enough on the bed and perp joints if so is the mortar the right consistency.
a little tip is to wet the joints with water before jointing. it stop the mortar drying out to quick
What is the proper way to hold the masonry trowel?
On the website http://www.masonryforlife.comthey explain: "Learning to hold the trowel correctly is important and will make the job easier. Gripping the handle with four fingers and putting the thumb on top of the metal band (ferrule) on the handle is how most masons hold a trowel."
1 yard cement is how many cubic feet
kakima is 100% correct, but to add to it so you understand how he got that 27 cubic feet... you can picture a cube.
A cubic yard is 3 foot tall x 3 foot wide x 3 foot high.
(A cubic foot is 1 foot tall x 1 foot wide x 1 foot high).
So 3 x 3 x 3 = 27.
Rewiring switch
I do not have a clue as to what you have but a simple switch has two connections and you can connect either way.
Not finding what you are looking for?