Oster Pets - Others - Recent Questions, Troubleshooting & Support
Oster gentle paws troubleshooting
I've literally JUST opened a brand new one and have the same issue...what gives? Return and replace? Repair? Or different brand all together please? Thank
How do I change the blade?
There is a small button at the bottom edge of the blade, push it in and at the same time push the blade teeth away from the clipper. The blade will hinge away from the clipper, you then lift the blade up off the tongue. When fitting another blade pop it onto the tongue, turn the clipper on and snap the blade shut.
How to put a oater a5 blade back together
There needs to be a video for this one but if you look at your other blades they can give you a guide. I wouldn't take the others apart though.get your pieces together the best you can. Don't forget the little plastic sliding piece. When you tighten the screws tighten the two equally and try your best to align everything as much as possible. Now look at your cutter blade and make sure the teeth don't stick out higher than gaps of the teeth on the main part of the blade. This will cut a dog.
Oster clipper
It sounds like a faulty motor if they are under a year old send then back who you purchased them from otherwise it could be a costly repair.
Dog Clippers
120v plugged in 220v
oops, you may have blown the circuit board or possibly the motor either way its not going to be a cheep fix. 120v clippers are not ment for 240V
Oster A5 clippers
Let Oster sort it out under guarantee. If you mess about you are likely to kill the guarantee.
Where do i grease a oster shearmaster
Undo the 2 screws from the FRONT that go through the aluminium housing into the yellow housing. They are either side of the blade tension thumb screw. Pull the housing off and that will allow you to squirt the grease into the gear assembly.
11/7/2013 4:18:13 AM •
Oster...
•
Answered
on Nov 07, 2013
Not finding what you are looking for?