Neff Washing Machines - Recent Questions, Troubleshooting & Support
Neff dishwasher tap light flashing -
If your Neff dishwasher is showing a flashing tap light, it typically indicates a water supply issue. Here's a short guide to address the problem:
- Check Water Supply: Ensure the water supply valve under the sink is fully open.
- Filter & Hose: Examine the inlet hose for kinks or bends and the filter at the connection point for blockages.
- Water Pressure: Low water pressure can also trigger this warning. Verify that your home's water pressure is adequate.
If these steps don't resolve the issue, there might be a more complex problem, such as a faulty water inlet valve or a problem with the dishwasher's control system. In such cases, consulting the user manual or contacting Neff customer support for further assistance would be advisable.
Neff error code E5123. What is it
I am not sure if this applies to your model as I translated it from German.....
Error E5121, E5122 or E5123: Problem with the pump
On FullSteam steam ovens, the display may show error codes E5121, E5122 or E5123. These indicate that either the pump or the water hose are clogged or calcified. To rectify the fault, proceed as follows:
1. Descale the device according to the operating instructions.
2. Use the special liquid descaler from our NEFF shop for this.
3. If error E5122 occurs when rinsing after descaling, it can be rectified by waiting about 30 minutes after inserting the tank with fresh water before closing the shutter and thus continuing the rinsing process. The pump then has time to cool down. It is particularly stressed during descaling and can cause the malfunction if it heats up.
NEFF washer not starting. error code 3/flashing anti-crease butto
This may be a simple control fault that can be reset by unplugging for 5 minutes or switching the breaker switch off for five minutes also. if the five minute reset doesn't restore the machine to its original operational value, you will then need to replace the main control board in this unit. it has failed.
My Neff washing maching does not take the fabric softner
Sounds like it needs unblocking....you need to remove the tray that holds the softfenervand unblock the guns that builds up in the tube with a qtip and old toothbrush..thus has to be cleaned periodically..otherwise when it fills up with water on final rinse it won't drain out.
E - 01, NEFF WASHER DRYER
there is to your right an bottom of washer a small door open it an you should see a small switch that you can take a small long screwdrive pess it down an door will unlock ok
I have a NEFF W4380
This is a problem if you cannot get hold of the wire through a hole in the inside drum then there is only one way. open the outer tank. This can be difficuilt as most machines will not allow this unless the complete outer tank is removed after the top lid is removed. The outer tank has to be lifted out of the case as it hangs on springs with drive motor. Big job not sure if you up to it. maybe check u tube how to remove outer tank from casing of front load WM
Not finding what you are looking for?