Miele Washing Machines - Page 3 - Recent Questions, Troubleshooting & Support

I need the model number to be able to help you.

does your machine have a drain trap-clean that out-if you still are getting the message,there may be a problem with you drain pump-check it for blockage. the check inlet means you have a water supply problem-either blockage or no pressure coming into the machine-both supply and drain can get clogged and bring your laundry to a halt-cheers Denny

Contact Miele directly to request a wiring diagram and parts list.

Water path control system faulty. The power-programme module (ELP) cannot register a valid position of the water path control unit within approx. 80 s of it being switched on. You have to replace water intake system. The top of the soap dispenser with pathway selector

sounds like the main motor brushes need replaced as it is overheating

• get the service manual yet/
• or call for service.?

Added Model Number to this post and deleted duplicate post. Refresh the page to see your post published. It sounds as though the water inlet valve has failed. The humming is the solenoid trying to open. https://www.google.com/search?q=miele+w5748+water+inlet+valve ..

drive motor capacitors might be getting weak

I've published some 'Tips' on the WT945's dryer problems. Hope these help. Best to read in order.

http://www.fixya.com/support/r4177912-miele_wt945_dryer_problems_stage_stage

http://www.fixya.com/support/r4177920-miele_wt945_dryer_problems_stage_1_fix

http://www.fixya.com/support/r4177928-miele_wt945_dryer_problems_stage_2_fix

http://www.fixya.com/support/r4177934-miele_wt945_dryer_problems_stage_3_4_fix

Question edited for full make and model.Question moved to Miele category.Yes, the water inlet valve is not shutting off properly. They wear and stick.Replacement is $40AUS and videos on how to change them.https://www.google.com/search?q=W820+washing+machine+replace+water+inlet+valve..

It just needs lubricating. The most likely place is the idler wheel on the belt drive. also lubricate the rear drum bearing, the fan and the front drum slides (some have oiled felt pads, so have rollers. Disconnect it from power, pull it out and tip it on its back, and your can easily get to the idler pulley and the rear bearing. To do the job fully, you remove the case. The screws are at the back. https://www.google.com/search?q=Miele+Novotronic+T490+has+developed+a+squeak ..

The hose might need to be replaced on your washing machine.

You can take help from - https://realappliancerepair.com/

The back panel is held on by screws. There should be four screws along the top of the panel, two near the bottom corners, and one in the center near the bottom. Once these screws are removed, the panel should come off easily. The belt is located under the panel, and can be replaced by following the instructions in your owner's manual. If you don't have your manual, you can usually find it online by searching for your model number. Hope this helps!

Could be a malfunctioning cycle timer

Quite likely

possible cogs under agitator bad replace if ok check belt

belt loose or under agitator cogs worn and drum slipping

" stuck on the 'tin e cycle' "?? Suggestions here is that it is the flood sensor. Try restting it by cutting the power for an hour. https://www.google.com/search?q=Miele+G+892+SC+is+stuck+on+the+tin+e+cycle ..

Is the dishwasher working at all? Instead of telling me what you checked, tell me what it is doing right and what’s wrong.