Miele Coffee Makers & Espresso Machines - Recent Questions, Troubleshooting & Support
I have a message: Empty the drip tray, but when I empty it, i still get the same message and the machine will not respond to any arrow inputs, so, I can't make any drinks
I have never had seen this problem ... however assuming the tray contacts are not shorted in any way ... its likely to be a problem with contacts in rear of the tray cavity. I would check the following;
1. Remove drip tray and shine a torch into the tray cavity to inspect the receiving contacts that accept the tray contacts. Perhaps theses contacts are shorted in some way.
2. The next step is to open up machine, but you need to be suitably experienced with electrical appliances to perform this step. Disconnect the power at the outlet (or if this is not accessible than at the fuse box). Remove the machine from the cavity and remove the rear panels (making note of which screws go where). Locate the wires that terminate on the contacts on the rear side of tray cavity. Disconnect the wires from these contacts. Replace panels and then reapply power to unit. If this solves your problem .. then there must be a short on the contacts in rear of tray cavity. If this does not solve the problem then trace this wire back to control board and remove wire at the control board. Again replace panels. If this solves problem then there must be a fault in the wire which can be fixed/replaced.. If this does not solve the problem then it would appear to be a problem with control board and best to call Miele.
Please come back if you need more help and also once you solve the problem .. to explain what went wrong. regards
Miele fashion master powers on but can't get any steam
If your Miele Fashion Master B2826 is not producing steam despite powering on, there are a few troubleshooting steps you can try:
1. Check the water level: Ensure that there is sufficient water in the water tank. If the tank is empty or below the minimum level, refill it with clean water and ensure it is securely placed in the machine.
2. Clean the steam vents: Over time, mineral deposits and debris can accumulate in the steam vents, hindering the flow of steam. Use a small brush or a pin to gently clean the steam vents and remove any obstructions.
3. Descale the appliance: If the steam vents are heavily clogged, it may be necessary to descale the appliance. Follow the instructions provided in the user manual for descaling the Miele Fashion Master. Descaling helps remove mineral deposits and can improve steam production.
4. Check the steam settings: Verify that the steam settings on the appliance are correctly adjusted. Ensure that the steam intensity and temperature settings are appropriate for your needs. Consult the user manual for guidance on adjusting the steam settings.
5. Inspect the steam hose and connections: Check the steam hose and its connections for any signs of damage or blockage. Make sure the hose is properly connected to the appliance and that there are no kinks or bends that could obstruct steam flow. If necessary, clean or replace the steam hose.
6. Perform a factory reset: Try performing a factory reset on the Miele Fashion Master. This can help reset any settings or configurations that may be causing the issue. Refer to the user manual for instructions on how to perform a factory reset.
If none of the above steps resolve the issue and your Miele Fashion Master B2826 is still not producing steam, it is recommended to contact Miele customer support or a qualified technician for further assistance. They will have specific knowledge and expertise to diagnose and address the problem with your appliance.
Please note that when working with steam appliances, it is important to exercise caution as they involve high temperatures and pressure. Always refer to the manufacturer's instructions and prioritize your safety.
Miele CM 6350 randomly shuts down
When was it last serviced by the local dealer? The machines need servicing at least once a year. There are a lot of O-rings that need replacing, plus parts get sticky and pipes get blocked.
Not finding what you are looking for?