Logitech Wingman - Recent Questions, Troubleshooting & Support

Yes And Know, It works with some games, it is a trial and error, there is a few posts online with games that it works with, I have one and it works with Grand Turismo 5 and Smash Cars, I have not tried it on any others, but it does work on some, 

This may help; https://www.youtube.com/watch?v=Tj4CXixMYIQ

In windows, go to your control panel in settings. In there, there should be a link for 'game controllers' or similar. Make sure your joystick is plugged in. When the settings start, you should see the joystick mentioned. Click this and then calibrate it from there. Don't forget to save before leaving.

Hello there Usually these JS automatically calibrate when intalled, but...some like olders models, have problems, with sensors, or bad calibrations inside the rotor ans sensors area. for those fixes, you have to open carefully the JS and look for the sensors that usually are two optical sensors, and clean good, with computer air spray, sometimes that did the trick, but others, its a sensors, problem. you have to RMS the product, or use your warranty. hope these helps!

Here: http://www.bioticaindia.com/wingman-extreme-digital-3d.html
Although a lot of people seem to have problems with it.

The drivers from Logitech help and can be downloaded from thier support site. The software they have lets you use profiles for all the games you play with the joystick, that way you don't have to constantly calibrate it for each game. The windows drivers will work the joystick....just have to go to control panel, game controllers and enable and calibrate the joystick.

From my experience,yes but I can't find any drivers online, FFB works with the windows generic driver :)

If the driver doesn't remedy your issue try using the compatability run as in the properties tab. Run in Win-XP in any format you like.

The the ring with 5 like screws is just cover that can be gentle forced out with a flat screwdriver. Then comes off the power control and the rubber gasket. Finally the top cover comes out. Simple.       coco13cos(Romania)

Please go to this link: http://www.logitech.com/en-us/support/extreme-3d-pro?osid=13&bit=32 and download the soft ware for driver

These cap screws thread into the basket inside the hull of the WingMan. This basket holds the mechanical parts and the potentiometers. If you wish to take a look on the interior of the hull (or case), it's better to open below; the bottom plate is secured by 5 Phillips screws located in the middle of the cushioning rings - except one of them, located nearby. Be careful.

Hi,

For your Extreme™ Digital 3D, pls click here. You would be asked for your PC's Operating System (Vista or XP or others), thereafter which file you need (Logitech Gaming software or the Wingman Clear Calibration Utility) and finally whether for 32 bit or 64 bit. Pls follow onscreen instructions.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.