Laser Optics - Recent Questions, Troubleshooting & Support
How do i mount my 650 laser sight to my bone collector rifle.
www.gamousa.com > Optics > Airgun Lasers and Lights
650nm Red Laser Sight with Weaver style rail mount.
www.
gamousa.com/category.aspx?catID=4
Air Rifle Scope Mounts/Rails. Air Rifle Scope Mounts/Rails. Air Rifle Sights. Replaceable sights for air rifles. Air Rifle Spare Parts. Replaceable parts for air rifles.
12/25/2015 11:55:23 PM •
Laser Optics
•
Answered
on Dec 25, 2015
I have a red laser
I think you are asking, if you are sighted in (holographic) can you then adjust the laser to that point of aim and then rely on the laser to be "ON TARGET" at a usable distance, the answer is yes. But if you can sight in at 15 yards using the laser. adjust you shots hi ( You aim your laser low, so your shots will be above your point of aim 1 inch) with this shot placement you should be on at 100 to 115 yards.If you can be very precise at 15 - 20 yards you should be very close out at 100. Hope this helps Fix Ya up.
Hello my new m4a1 replica was shooting fine
why did you recharge it if it was still shooting ok????
my gess is you have just burt out the battery by over charging it
you can over charge a battery,,,and if you do it kills it off!
try a new battery in the gun
Airsoft battery busted
New battery is all i suggest , you really screwed it up it probally wont work but if it does it will eventually blow up on you as it is not discharging properly, but there cheap if there locally available. So just get a new one and dont play with the wires next time and get a proper airsoft gun.
Laser engrave a gun barrel
this is highly UN-Recommended.
is the barrel is too thin or built poorly you can actually cut through and ruin it.
if you want to paint it the i would use Krylon spray paint
My laser for my m82 airsoft gun is broken and i
follow the wires to and from the laser. There should only be two wires that make it work. A positive and a negative wire that hook up where the battery connect. if the wire is not connected you have to make the connection again. To make it stay connected you may have to soder the wire back together. Also, double check that the batteries have not ran out of power.
Not finding what you are looking for?