Konica Minolta bizhub - Answered Questions & Fixed Issues

help me my konico minolta bizhub 184/164 error (C2558) my mail id - [email protected]

Konica-Minolta bizhub Pro 950 - Error Code

Printcopy.info https://printcopy.info > model=bizhub+Pro+950 Code: C-8003 · Description: When the main power switch (SW1) is ON, there is no response to the initial communication request from the main body to the DF even ...

• Konica-Minolta bizhub Pro 950 - Error Code

  https://printcopy.info > model=bizhub+Pro+950 Code: C-0003 · Description: Main body drive serial input abnormality 3. Within a specified period of time after the power ON ACK, a serial data is not received ... ..

Here’s your GEEK-steer …

This thread appears to cover the solution to your problem related to error "C5102: Main Motor’s failure to turn":
http://www.copytechnet.com/forums/konica-minolta/15515-c252-m1-operation-test.html

In addition, here’s the link to “Bizhub C250P” related support downloads:
http://kmbs.konicaminolta.us/content/support/supporthome.html

Hope this helps, and please post back with a status report and/or any further assistance you might need.

"Today's the best day of my life...and NOW you're part of it!"

Replace the black developer unit and black drum

KONICA MINOLTA BIZHUB 211 FUSER UNIT 230V / 4034r70100 (surplustoner.com) Here is the image of the fuser

Open the mid section of the copier and pull out main section. Then re-install. The code mean the the fuser (The large device on the left hand side that melts or fuses the toner to the paper is not connecting properly to the electrical connections in the back where it plugs into. Could be that the connector is broken because some slammed the mid section to hard. Or that you need to give the section a better/some what harder push when you close it. Might want to remove the FUSER unit and put a flashlight to the back make sure the connector is ok and check the connector on the fuser itself!

Check all fans located inside the machine

Replace the drum and developer. Clear the associated counters first in service mode. Then replace the developer and drum then run the F8 procedure in service mode.

A/C signal out your wall outlet or the you are using a European model machine in the US or vise versa. Also check the electrical cord

Requires you to access service mode first, then Stop, 0, Clear.

What is Polycope? What is prechaufage?

Did you reset the counters for the drum and developer before you installed the drum and developer. And did you run the TCR Adjustment. As required.

Replaced. Or it could be the main board.

replace the magenta image unit

Replace the black image unit not toner

What is the model number? Ball park! replace the black developer unit and black drum

What is the model number?

Would help to know the model of the machine

Replace the transfer belt.