Konica Minolta bizhub - Recent Questions, Troubleshooting & Support - Page 9
Error Code C-6701
Any one of theses:
CCD board (CCDB)
Exposure lamp (L1) My Number #1 does the Bright Light under the big glass come on?
L1 inverter (L1 INVVB)
Scanner motor (M2)
Overall control board (OACB)
Error code ccf01
One of the rarest machines in the Konica Minolta line up!!!!!
A printer without a control panel. the code deal with one control board not talking to another, recommend a tech look at it he might be able to re-flash the firmware the copiers operating system worse case one or both boards are bad. Is the machine on a good surge protector not an Ace hardware 9.99 special? Nothing against Ace. But a thousand dollar machine should be protected with a good minimum 100 dollar surge protector. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
RESET TRANSFER BELT BIZHUB C350
A new belt will have to be installed at which time the fuse in the new belt will be blown to start a new count from 0. Now you can replace the fuse in the old one if you know how.
Please install the image unit correctly and close all doors
Sometimes just open the doors and closing them a few times will work its sensing somethings open ,Make sure all is closed you may have too reinstall drivers. start over read all directions sometimes we get burnt out on trying to get something going give it a break for a bit then try again. could be a firewall or anti virus cause problems to.
C353 loud grinding noise
Are you getting any warning on the Screen? Such as Error Code or Replace the waste toner Box etc.
Not finding what you are looking for?