Konica Minolta bizhub - Recent Questions, Troubleshooting & Support - Page 4
Minolta codes
Level Adjustment error. Has the drum and the developer unit and developer been replaced? Has the drum unit/assy. been cleaned including the sensor!!!!!!!!!
Error code c2152
good toImax Konica Minolta C451 BizhubI have a problem is the cod C2151 what to do Thanks
Error code C-D351 on a Bizhub C250
didn't find this code, so dis you read the code correctly and is the model write. you can try troble reset. turn off printer and then on again, holding utility key down. push trouble reset, and reboot again.
C-dc30 how to reset code
Sir/Mam,
You hit a serious code, noting can be done, this code requires a tech to come out and remove a chip inside the machine, which is then sent to Konica Minolta, then on to the US SECRET SERVICE since someone attempted to counter fit US currency!!!!!!!!!!!, until the US Secret Service determines what was done the machine stays inoperative , once what happen is determined tech will come out reinstall the chip reload firmware, and .NEVER EVER PLACE ANY CURRENCY ON A COPIER all the machine now a day have Bank Note chips.
Error 2703 en konica minolta bizhub 750
Directly below the drum is the transfer and separation ration unit. which houses two very, very thin gold plated wires the one on the right is the transfer wire which transfers the image off the drum on to the paper as the paper goes over the wire while the drum place the image on the paper. the second wire is separation wire which has an AC signal on it to prevent the paper from sticking to the drum. The second wire might be broken. Have it replaced best to have booth done at the same time since unit comes out? or the spring at rear of the unit are not making good electrical contacts. Ensure power is off. as they do carry High Voltage during the normal operation.
Error code d358 bizhub c250
Was the main board replaced? The NVRAM chip was not properly replaced still mite be on the original board . Was the firmware properly installed
Error code c2558 for konika bizhub 215
Abnormally high toner density detected black TCR sensor
TC ratio in the imaging unit, which is determined by toner replenishing amount control mechanism, is a predetermined value or more for a given number of times consecutively.
check for developer
check TCR sensor
check toner sensor
check the PRCB
My photocopier bizhub 210 is not supplying toner why
Sir,
Power off the machine. Then remove the toner bottle, be careful the hole might be on the bottom and the toner is going to go everywhere. Then close the toner cover and turn on the machine. Let the machine go through it normal routine. When it asks for toner install the toner bottle correctly. If that does not work, you might have a bad motor or the home sensor or actuator for the toner bottle is bad worse case the control board is bad.
Does it say image unit or drum????????
My bizhub 210 photocopier displayed supply toner and toner has been changed still writing same why?
Power off the machine. Then remove the toner bottle, be careful the hole might be on the bottom and the toner is going to go everywhere. Then close the toner cover and turn on the machine. Let the machine go through it normal routine. When it asks for toner install the toner bottle correctly. If that does not work, you might have a bad motor or the home sensor or actuator for the toner bottle is bad worse case the control board is bad.
Does it say image unit or drum????????
Not finding what you are looking for?